Keys Fitness Alliance A6t Owner's Manual

Keys Fitness Alliance A6t Owner's Manual Manual pdf 21 page image

Maintenance Instructions21WARNING! Before performing any maintenance to your treadmill, always unplug the power cord fromthe surge protector.CLEANING: Routine cleaning of your unit will extend the life of your unit.WARNING! To prevent electrical shock, be sure the power to the treadmill is OFF and the unit is unpluggedfrom the wall electrical outlet before attempting any cleaning or maintenance.AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water damp-ened soft cloth to remove excess perspiration. USE NO CHEMICALS.WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts thebelt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.DECK LUBRICATION: The walking belt has been pre-lubricated at the factory. However, it is recommend-ed that the walking board be checked periodically for lubrication to ensure optimal treadmill performance.Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the walk-ing board as far under as you can reach. If you feel signs of silicone, no further lubrication is required. If itfeels dry to the touch, lubrication is needed. Keys Fitness recommends “Lube N Walk” for cleaning and lubri-cating the treadmill belt and deck. Ask your retailer or call Keys Fitness at 888-340-0482. You may also usesilicone such as “Napa 8300” (available at most NAPA Auto Parts stores).TO APPLY LUBRICANT TO THE WALKING BOARD1) Position the walking belt so that the seam is located on top and in the center of the center of the walkingboard.2) Insert the spray nozzle into the spray head of the lubricant can.3) While lifting the side of the walking belt, position the spray nozzle between the walking belt and the boardapproximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving fromthe front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 secondson each side.4) Allow the silicone to ‘set’ for one minute before using the treadmill.WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a cleantowel.