Keurig B70 Owner's Manual

Also see for Platinum B70: Use and care guide Owner's manual Owner's manual Setup guide Owner's manual

Contents

Keurig B70 Owner's Manual Manual pdf 8 page image

Brewing Your First Cup (Continued)SECTION 1 First Brewadding WaterThe LED Control Center of your Brewer willindicate when the water level in the WaterReservoir is low or if the Water Reservoir hasbeen removed by illuminating the blue lightnext to ‘ADD WATER’ (fig. ). The Brewer willnot allow you to brew when the blue ‘ADDWATER’ light is illuminated.The Water Reservoir can be filled in two ways.1. Lift off the Water Reservoir Lid and pourwater directly into the Water Reservoirwhile it is still attached to the Brewer,then replace the Lid.2. Remove the Water Reservoir from Brewer byfirst removing Lid from the Water Reservoir,then lifting the Water Reservoir straight upand away from Brewer. Fill with water. Placethe Water Reservoir back on the Brewer andreplace the Lid.IMPORTANT: Do not remove the WaterReservoir during the brewing process.12. The red light next to ‘HEATING’ on the LED Control Center may be lit asthe water is heated for the next brew cycle. The Brewer will be ready foruse in approximately 15 seconds.NOTE: Following the brew, your Brewer will fill in preparation for the nextbrew. The pump will make a vibrating sound. This is normal.Stopping the Brew ProcessIf you need to stop the brewing after the process has started, press thePower Button to turn the Brewer ‘OFF’. The flow of coffee or tea will stop,the heating element will shut off and the green light next to the PowerButton will disappear.NOTE: You may get less coffee, tea or hot cocoa in your cup during your nextbrew. We recommend that you perform a cleansing brew with water only aftera terminated brew. Then your NEXT brew will be the proper volume.!$$7!4%2$% 3#!,%(%!4).'!54//&&0/7%2fig. 68