Kenmore 790.9535* Use & Care Manual

Contents

Kenmore 790.9535* Use & Care Manual Manual pdf 20 page image

Self-Cleaning (cont'd)Starting the Select Self-Clean Cycle or a Delayed Start Self-Clean CycleFor satisfactory results, use a 2 hour Self-Clean cycle for light soils and a 3 hour cycle for average or a 4 hour cycle forheavy soils. NOTE: The kitchen area should be well ventilated using an open window, ventitlation fan or exhaust hoodduring the 1st Self-Clean cycle. This will help eliminate the normal odors associated with the 1st Self-Clean cycle.To Set the Controls for a Self-Clean Cycle or a Delayed Start Self-Clean Cycle:(Note: If you do not want to start a Delayed Self-Clean Cycle, skips steps 2 & 3.)1. Be sure the clock shows the correct time of day.2. Press _. The" : " in the time of day will flash.3. Press and hold the A pad to scroll to the time to start the delayed Self-Clean cycle. Release the pad when thedesired time is displayed.4. Press _. "------" appears in the display.5. Press the A or V once. "3:00" appears in the display for a 3 hour cycle. To change to a 2 hour cycle press V.,"2:00" appears in the display or to select a 4 hour cycle press A. "4:00" appears in the display.As soon as the controls are set, the motor driven lock will begin to close automatically and the "LOCK" indicator lightwill flash. DO NOT open the oven door while the light is flashing (it takes about 15 seconds for the oven door to lock)."CLn" will appear in the display during the Self-Clean cycle and the "LOCK" light will glow until the Self-Cleaning cycleis complete or cancelled and the oven temperature has cooled.When the Self-Clean Cycle is Completed:1. The time of day or "End" will appear in the display window and the "Clean" and "LOCK" light will continue to glow.2. Once the oven has cooled down for about 1 HOUR and the "LOCK" light has gone out, the oven door can be opened.3. If "End" is in the display and the Select Clean indicator light remains ON, press _. The time of day will appear in thedisplay.NOTE: When the oven is cool, wipe away any residue or powdered ash with a damp cloth or paper towel.Stopping or Interrupting a Select Self-Cleaning CycleIf it becomes necessary to stop or interrupt a Self-Cleaning cycle:1. Press @.2. Once the oven has cooled down for about 1 HOUR and the "LOCK" light has gone out, the oven door can be opened.3. Restart the Self-Clean cycle once all conditions have been corrected.To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the side ofthe oven when opening the door to allow hot air or steam to escape.DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoidpossible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be VERY HOT.2O