Kenmore 66572179301 Use & Care Manual

Also see for 665.7213 Series: Use & care guide Use & care guide

Kenmore 66572179301 Use & Care Manual Manual pdf 23 page image

To Install Starter and/or Bulb:1. Fit starter prongs into starter mounting base and turnclockwise.2. Slide bulb prongs into bulb mounting base ends. Roll the bulbforward or backward 90 ° until it clicks.3. Push down on the left end of the bulb mounting base. Whenthe assembly latches, it will click.2. Pry door stop clip free and remove from front frame hingeslot. Take care not to scratch finish.3. Repeat procedure for other door stop clip.To Remove:1. Open the oven door. Insert door removal pins, included withyour range, into both hinge hangers. Do not remove the pinswhile the door is removed from the range.A. Removal pinsB. Hinge hanger2. Slowly close the door until it rests against the door removalpins.3. Grasp the door on the sides with your fingers on the front ofthe door and your thumbs on the inside surface.4. Pull door straight up, then toward you. Hinge hangers willslide out of front frame hinge slot. Do not remove doorremoval pins until the door is replaced on the range.Replace lens cover. Position the 2 rear lens cover tabs in frontof the 2 metal spring clips (located directly behind the bulb).Push back and down on the lens cover to lock into position._'z:_ _i_//ii iii iiiii i¸ -__--_5. Plug in range or reconnect power.For normal range use, it is not suggested to remove the ovendoor. However, if removal is necessary, make sure the oven is offand cool. Then follow these instructions. The oven door is heavy.Before Removing:1. Use a putty knife or screwdriver and insert it at the bottomcorner of the door stop clip.AA. Doorstop clipTo Replace:1. Grasp the door on the sides with your fingers on the front ofthe door and your thumbs on its inside surface.2. Hold oven door so that the top edge of each hinge hanger ishorizontal. Insert hinge hangers into the front frame hingeslots.3. Tilt top of door toward range. Slide hinge hangers down ontofront frame support pins. Make sure the hinge hangers arefully seated and engaged on the support pins.A. Hinge hangerB. Door frame hingeC. Support pins23