KeyGrabber USBCopyright © 2013 KeeLog7Viewing recorded dataOnce keystroke data has been recorded, it may be retrieved on any computer with a USBport. This is done by switching to Flash Drive mode. The KeyGrabber USB and keyboardshould be connected in the same way, as during normal recording.Each device has a built-in 3-key combination (by default K, B, S). Press these 3 magic keyssimultaneously to trigger Flash Drive mode.After a few seconds, the hardware keylogger will automatically get detected as a massstorage device. The operating system will use the standard built-in mass storage driver (MSWindows 7 in the following examples).Depending on the drive letters available, the device will be visible as a new drive, for exampleF:. Use the systems file manager to browse this disk (for example Explorer). The keyboardwill be disconnected and unavailable, so the mouse must be used to browse the disk.