Menu
Kantech Expansion Modules Cabinet KT-MOD-CAB Installation Sheet
  |
Telephone: 1 (450) 444-2030 • Toll free: 1-888-222-1560 • Fax: 1 (450) 444-2029 • Internet: www.kantech.comCopyright © 2008 Tyco International Ltd. and its Respective Companies. All Rights Reserved • Specifications may change without notice.Kantech and the Kantech logo are trademarks of Tyco International Ltd. and its Respective Companies.1KT-MOD-CABEXPANSION MODULES C ABINET I NSTALL SHEETDN1806-0809OverviewThe KT-MOD-CAB cabinet is an enclosure for the KT-MOD-REL8, the KT-MOD-INP16and KT-MOD-OUT16 expansion modules. Up to 6 modules can be installed in thecabinet.Content• 698-009K: Black cabinet• KT-MOD-SPI36: 1 m (3.0 ft) SPI cable assembly with 1 SPI connector• KT-LOCK: Lock with 2 keys• DN1805: Cabinet Install Sheet, French version• DN1806: Cabinet Install Sheet, English versionRelated Documentation (each document is enclosed in their corresponding box)• KT-MOD-REL8: KT-400 Expansion Module 8-Relay with SPI Cable, Install Sheet, DN1786• KT-MOD-INP16: KT-400 Expansion Module 16-Zone Input with SPI Cable, Install Sheet, DN1776• KT-MOD-OUT16: KT-400 Expansion Module 16-Output with SPI Cable, Install Sheet, DN1781Cabinet Description• Dimensions: 54 cm (21.2 in) High x 29.2 cm (11.5 in) Wide x 7.6 cm (3 in) Deep• Eight (8) standard knockouts 1.9 cm (0.75 in): 4 on top, 2 at the bottom and 1 on each bottom side• Two (2) additional openings, 6.3 cm (2.5 in), on the back panelInstallation1. Insert the nylon standoffs into the back panel of thecabinet.Note: Make sure the cabinet is in the upwardposition and the tamper switch location is on theright.IMPORTANT: Don’t install the expansion modulesbefore checking their locations within the cabinet.Trying to pull out the module from its standoffswould damage it.2. Secure the cabinet to the wall in the desiredlocation. Use appropriate wall anchors whensecuring the cabinet to drywall, plaster, concrete,brick or other surfaces.3. Mount the expansion modules on their standoffs.IMPORTANT: Make sure the modules terminalblocks are positioned towards the center of thecabinet.4. Run the 91 cm (36 in) SPI cable, provided with thecabinet, from the KT-400 controller or expansionmodules cabinet, through one of the knockouts, tothe 1 st module in the new cabinet. |
Related manuals for Kantech Expansion Modules Cabinet KT-MOD-CAB
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved