Menu
Kannad S185 501 Series Maintenance Manual
        |
Component Maintenance ManualP/N S185X501-XX25-63-06 Page 7001© KANNAD 2011JUN 16/2011ASSEMBLYTASK 25-63-06-400-801-A011. GeneralA. Introduction(1) This section gives the procedures for the assembly of the equipment. The components areidentified by their “Figure - Item” number in the Illustrated Parts List (Refer to Figure 10001 / 25-63-006-991-010-A01).(2) Assemble the unit in a clean, dust-free area in accordance with the procedure that follows. Usegood standard workshop practices.(3) Examine the parts ( PAGEBLOCK CHECK) before you start the assembly.B. Special InstructionCAUTION: BEFORE WORK ON THE ELT, MAKE SURE THAT THE FRONT PANEL SWITCH ISSET TO “OFF”.C. Tools, Fixtures and Equipment(1) Special Tools, Fixtures Equipment ListRefer to PAGEBLOCK SPECIAL TOOLS, FIXTURES, EQUIPEMENT AND CONSUMABLES.D. Annual Inspection KitNOTE: the parts of the annual inspection kit are also included in the battery kit P/N S1840510-01.For this reason, it is not necessary to use an extra annual inspection kit when a battery kitis used. When a battery kit is used, all the parts must be used excepted two screws and thelabel EES1923.(1) Annual Inspection Kit ContentTable 7001 / 25-63-06-992-901 : Annual Inspection Kit Content(2) Use of the annual inspection kitNOTE: The purpose of the annual inspection kit is to replace the necessary parts when theELT is opened without battery replacement.KIT PAR NUMBER S1840510-02Part Number DESIGNATION Numbers0141822 O-RING 10123831 CAPSULE,DESICCANT 10145234 SCREW, F HEXALOB. M3x16 A4 40146261 SCREW, F HEXALOB. M3x20A4 [only used for AP, AP (ER), AP-H, AP-H (ER)] 20136779 NUT, NYLSTOP M3 A4 40141787 LABEL, SEAL 10145250 LABEL, INSPECTION EES1923[not used for INTEGRA ELTs] 10145251 LABEL, INSPECTION EES1928 1The document reference is online, please check the correspondence between the online documentation and the printed version. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved