KETRON X1 Owner's Manual

Also see for X1: Supplementary instructions Schematic diagram

KETRON X1 Owner's Manual Manual pdf 56 page image

OUT ASSIGNThis menu controls the assignment of the various parts of the instrument on the 4 Audio outputsavailable. There are 2 separate modes for the audio assignment, one concerning the keyboard andthe other concerning the General Midi (GM).Keyboard Out AssignTo gain access to the menu from the main display:1 Press F 3 – Utility2 Press Page > to proceed to the second Utility page.3 Key F 6 – Keyboard Out Assign enables the control function of the outputs for theKeyboard, or rather over the various parts: Drums, Bass, Chords, Lower, Right, Microphone.L&R Standard: (F 1) normal stereo functioningmode of the keyboard with the Left/Mono 1 andRight 2 outputs.L&R Out 3: (F 2) this function is used to send one ormore parts of the instrument to Output 3 using the 2L/R stereo outputs at the same time.Use Cursor < > to scroll all the parts and use Value+ / - to confirm which parts are assigned to Out.3.The effects remain activated on Left and Right. Output 3 is without effects.L&R Out 3 & 4: this function is used to send one or more parts of the instrument to eitherOutput 3 or Output 4. The control is the same as above for L&R Out3.Using this combination, only the Chorus, Delay and Distorsor effects remain activated on theLeft and Right (the Reverb. is cut out).Separate 1, 2, 3, 4: this function enables the free assignment of the parts of the keyboard to anyof the 4 Outputs available. Using this combination, all the internal instrument Effects are cut out.The Cursor is used to select the parts and the Value + / - keys to select the Output.The Default function restores the initial conditions on each of the Out Assign combinations.GM Out Assign: Assignment of the separate outputs for the 16 GM parts. To gain access to themenu from the main display:1 Press F 3 - Utility2 Press Page > to proceed to the second Utility page.3 Press key F 7 – GM Out Assign.This section controls the assignment of theoutputs on the Percussion sections and on the16 General Midi partsThe selection of the parts and the assignment of the Outputs is performed in the same way as forthe aforesaid Keyboard Out Assign.The Default function – F 6 restores the standard mode on each of the combinations.53