KENT Superb Mineral RO Instruction Handbook For Installation, Operation And Maintenance

Contents

KENT Superb Mineral RO Instruction Handbook For Installation, Operation And Maintenance Manual pdf 8 page image

87iii. Settings TabSetting tab allows to set the Date, Time and customizedisplay brightness as per requirement.a. Clock Setupb. Date Setupc. Brightness Setupa. Clock SetupTo set time, click on the Clock setup once. A window willpop up as shown in the figure.Use the arrows to set the correct time.To save the time settings, press 'Save' button on theinterface once.Time saved message will pop up for 5 Sec., confirmingthat the settings has been saved.nnnNote: To go back to the settings menu click the return arrow or cancel buttonb. Date SetupTo set date, click on the 'Date Setup' menu once. A windowwill pop up as shown in the figure.Use the arrows to move to the correct date.To save the date settings, press 'Save' button on theinterface once.Date saved message will pop up for 5 Sec., confirmingthat the settings has been saved.nnnc. Brightness SetupTouch the 'Brightness Setup' button to set brightness level.Brightness levels can be set in a range of 0 to 26.Brightness levels can be increased or decreased bypressing left and right arrow as shown below.After achieving the correct brightness level, touch the'Save' button to save the brightness level.To cancel brightness setting, touch the cancel button.Thescreen will run with previously set brightness levels.nnnnTo ensure delivery of purer and healthier water, a micro-processor is installed in the purifier that performs thefollowing functions:-UV Stabilization Delay: To ensure that the UV lamp is pre-heated and is working at its optimum level before itstarts disinfecting water, the controller provides a two seconds delay to UV lamp when the purifier is switched on.During this period, only the UV lamp is switched on and other electrical devices of the purifier are switched off.Purification Delay: To ensure that the idle water lying in the internal pipes and in the UV chamber is disinfectedbefore being passed into the storage tank, the system provides a 5 seconds delay when the purifier is switched on.During this time, the UV lamp kills all micro-organisms that may be in the water inside UV chamber. After this delay,all other electrical devices such as booster pump and solenoid valve are switched on to start normalpurification process.Alarm: To ensure delivery of purer water, KENT Superb in-built micro controller controls and senses various vitalcomponents and displays their status on the digital interface.Computer Controlled OperationUV lamp FailureKENT Superb Mineral RO™ Water Purifier is equippedwith a safety feature, which displays a warning signal whenand if the UV lamps fails or stops working. The purifierwould stop purifying water till the UV lamp is not replaced.If the interface shows UV failure message, switch off thepurifier and call the service technician for help.Filter ReplacementThe in-built smart system will display a message, warningthe user to replace filter when less than 60 hours of filter lifeis left.On completion of filter life, 'Replace filter Message' will bedisplayed on the screen, and the purifier would stoppurifying water till the filter is not replaced.If the interface shows 'Replace Filter Message', switch offthe purifier and call the service technician for help.

/ 11

Related manuals for KENT Superb Mineral RO