KENT EVOLUTION4 Owner's Manual

Contents

KENT EVOLUTION4 Owner's Manual Manual pdf 5 page image

LOCATIONSelect a location for your wood heater with greatcare.* Do not place your heater in areas of hightraffic, near furniture or draperies.* Check that the intended location will notinterfere with ceiling joists, rafters, valleys andridges.CLEARANCESIt is vital that the heater be installed the properdistance from combustible surfaces like wood,gyprock and curtains.The diagrams show both parallel and cornerinstallations.Failure to maintain these minimum distances mayresult in a fire for which your insurer may refuse tocover.REDUCED CLEARANCESThese clearances can be reduced with properheat shielding. Basically a noncombustiblesurface is placed between the heater and thecombustible wall. It is vital that an unobstructedair flow be maintained between the two surfacesto remove excess heat.HEARTH CLEARANCESIt is necessary to ensure that the heater ispositioned on the hearth so that the requirementsbelow are observed. The front of the hearthshould extend past the heater door by the distancespecified as D. The side of the hearth shouldextend past the heater door by the distancespecified as E on each side.INSTALLATION - FREESTANDINGHEATERS ONLYGFEDCBAModelAll dimensions are in millimetresEvolution 8Evolution 6Evolution 4with Maxiheat Default Flue Kitwith decromeshwith flue pipe, no shieldwith decromeshwith Maxiheat Decromesh Flue Kitwith Maxiheat Default Flue Kit103312302006701255252501033123020067020052537593099020040050400100930990200400100400300880940200430100300150880940200430170300275EDG minFminHearth Dimensions andClearancesCCorner InstallationABParallel Installation5