FACTORY RESETPress DOWN button for five (5) seconds to enter FactoryReset. When the display is blinking ‘RESET’, press STARTbutton to reset all data to factory default. If you do not wantfactory reset, press MEMORY button to exit.- Clear all measurement data- Set-up items- Calibration dataFactory reset default:a. BACKLIT ONb. SOPRANOc. COMBO MODEd. HIGHWAYe. VOICE ONf. VG-2 ONg. LASER SCRAMBLER ONh. SETUP DATA DEFAULTi. CALIBRATION DATA DEFAULTj. SAFETY ALARM ONREPLACING FUSETo replace the fuse, unscrew the top of the plug. Remove andcheck the fuse to see if it has blown. If it has, replace it.SPECIFICATIONSRADARReceiver Type: Dual conversion superheterodyneAntenna Type: Linear polarized. self-containedAntennaDevice Type: Frequency discriminatorFrequency of Operation: 10.525GHz/±50MHz(X-Band)24.150GHz/±100MHz(K-Band)34.700GHz/±1,300MHz(Ka Super Wideband)LASERReceiver Type: Pulsed laser signal receiverDetector Type: Digital signal processor pulse widthdiscriminatorOptical Sensor: Dual convex condenser lens and highspeed photo diode detector905±50 nanometers(nm)ACCELEROMETERSensor: Tri-axis(X,Y,Z)±2GGENERALOperating Temperature Range: -20℃ ~ +70℃Storage Temperature Range: -30℃ ~ +100℃Power Requirements: 12V to 15V DC, 150mA, negative groundDimensions: 1.2" (H) x 2.9" (W) x 4.6" (L)Weight: 4.0 ounces*Specifications are typical. Individual units might vary.Specifications are subject to change without notice.27TRAXX OWNER’S MANUAL26TRAXX OWNER’S MANUAL