KAM SF6A Safety Information Manual

KAM SF6A Safety Information Manual Manual pdf 1 page image

SF6ASAFETY INFORMATIONRead all documentation before operating your equipment. Retain alldocumentation for future reference.Save the carton and packing material even if the equipment has arrived in goodcondition.Do not spill water or other liquids into the unit.Make sure power outlets conform to the power requirements listed on the backof the unit.Do not use the unit if the electrical power cord is frayed or broken.Always operate the unit with the AC ground wire connected to the electricalsystem ground.Have gain controls on amplifiers or consoles to any other voltage source, suchas a battery, mains source, or power supply, regardless of whether theamplifier or console is turn on or off.Power down & disconnect units from mains voltage before makingconnections.Do not use the unit near stoves, heat registers, radiators, or other heatproducing devices.Do not block fan intake or exhaust ports. Do not operate equipment on asurface or in an environment which may distort the normal flow of air aroundthe unit. If the unit is used in an extremely dusty or smoky environment, theunit should be periodically “blown free” of dust.Do not remove the cover. Removing the cover will expose you to potentiallydangerous voltages.Do not drive the inputs with a signal level greater than required to driveequipment to full output.Do not run the output of any amplifier back into another input.Do not ground the red output terminal, never connect a red output terminal toanother red output terminal.In case of mal-function this device should be serviced by qualified servicepersonnel only.TECHNICAL SPECIFICATIONSSpeaker Impedance:8OhmsRated power:50Wrms Frequency-range:55Hz~20KHzPower [Max]:80W AmplifierBass speaker:6.5" Power output:50WrmsSpeakers:0.75" tweeter Frequency-range:20Hz~20KHzConnections: 2-pole terminal Equalization:2 bands EQ ±15 dBSensitivity:89 dB@ 1W/1m Gain:30dB(max)Dimension [H W D]: 350×210×205mm

/ 2

Related manuals for KAM SF6A