Kärcher K 6.200 Manual 

Also see for K 6.200: Original instructions Service manual

Contents

Kärcher K 6.200 Manual  Manual pdf 19 page image

– 10CautionProtect the appliance and its accessoriesagainst frost.The appliance and its accessories can getdestroyed through frost if there are any wa-ter residues in them. To avoid damage tothem: Completely drain all water from the ap-pliance: Switch the appliance on withdetached high pressure hose and de-tached water supply (max. 1 minute)and wait, until no more water exits at thehigh pressure connection. Turn off theappliance. Store the appliance and the entire ac-cessories in a frost free room. DangerTurn off the appliance and remove themains plug prior to any care and mainte-nance work.Prior to longer periods of storage, e.g. inthe winter: Remove filter from suction hose for de-tergent and clean under running water. Pull out the sieve in the water connec-tion using flat-nose pliers and clean un-der running water.The appliance is maintenance free.Use only original KÄRCHER spare parts.You will find a list of spare parts at the endof these operating instructions.You can rectify minor faults yourself withthe help of the following overview.If in doubt, please consult the authorizedcustomer service. DangerTurn off the appliance and remove themains plug prior to any care and mainte-nance work.Repair works may only be performed by theauthorised customer service. Check whether the voltage indicated onthe type plate corresponds to the volt-age of the mains supply. Check the mains connection cable fordamages. Release the lever of the hand spraygun; the appliance will switch on. Check setting at the spray lance. Appliance ventilation.Switch on the appliance without con-nection the high-pressure hose (max. 2minutes) and run it until the water dis-charging from the high-pressure outletis free of bubbles. Switch off applianceand reconnect high-pressure hose. Check the water supply. Pull out the fine filter in water connec-tion using flat-nose pliers and clean withrunning water.Cause: Voltage reduction due to weakmains supply or when using an extensioncable. When switching on, first pull the lever ofthe trigger gun and then switch the ap-pliance switch to "I/ON".Frost protectionMaintenance and careCareMaintenanceSpare partsTroubleshootingAppliance is not runningPressure does not build up in theapplianceAppliance does not start, motorhums19EN