Kärcher K 502 Operator's Manual

Contents

Kärcher K 502 Operator's Manual Manual pdf 4 page image

3Water Supply(Cold Water Only)• Water hose must be at least 3/4 inch indiameter.• Flow rate of water supply must not fallbelow 2.5 GPM (gallons per minute).• Flow rate can be determined by runningthe water for one minute into an empty5-gallon container.IMPORTANT PRECAUTIONS – continued• The water supply temperature must notexceed 104°F/40°C.• Never use the pressure washer to draw inwater contaminated with solvents, e.g. paintthinners, gasoline, oil, etc.• Always prevent debris from being drawn intothe unit by using a clean water source.ASSEMBLY INSTRUCTIONSStep 2 Slide the hose caddy into the slotson the transport handle and snap into place.Step 3 Pull out the locking slide fromthe right side of the trigger gun handle,and insert the small end of the high pres-sure hose into place. Push the lockingslide back into the trigger gun to lock thehose in position.Step 1 Place the transport handle ontothe mounting brackets on the sides of thewasher and align the four holes. Hold eachfour-sided nut with one finger while insertingeach screw and tighten with a screwdriver.Step 4 Insert the Spray Wand Extensioninto the trigger gun. Press in against thespring tension and twist into the lock posi-tion. Turn the Spray Wand Extension Collarclockwise until tight.