Kärcher HDS 5/11 U/UX Manual

Also see for HDS 5/11 U/UX: Instructions Manual Manual Instruction manual

Contents

Kärcher HDS 5/11 U/UX Manual Manual pdf 18 page image

– 5 Insert the hand-spray gun in the holder. Appliance without hose drum:Wind up the high-pressure hose and hang it overthe hose storage. Device with hose drum:Wind up the high-pressure hose on the hose drum.Push in the handle of the crank to block the hosedrum. Wind the connection cable around the cable holder. Fasten the plug with the mounted clip.ATTENTIONRisk of damage! Frost will destroy the appliance if thewater has not been completely drained. Store in a frost free area.If the device is connected to a chimney, the followingmust be observed:ATTENTIONThreat of damage by penetrating cold air through thechimney. Disconnect device from chimney when outsidetemperature drops below 0 °C.If it is not possible to store frost free, shut down device.For longer work breaks or if a frost free storage is notpossible: Drain water. Flush device with anti-freeze agent. Screw off water supply hose and high pressurehose.Illustration Lay the appliance on its rear. Operate the appliance for a max. of 1 minute withcold water until the pump and conduits are empty.Note: Observe handling instructions of the anti-freezeagent manufacturer. Fill commercial grade anti-freeze into the waterconnection. Switch on appliance (without heater) till the appli-ance has been completely rinsed.A certain corrosion protection is achieved with this as well. CAUTIONRisk of personal injury or damage! Consider the weightof the appliance when storing it. DANGERRisk of injury! Risk of tipping with high inclines, if the in-clination is too large to the side and with unstable sur-faces.– The appliance should only be used on gradients ofmax. 2%.– Only use the machine on sound surfaces.ATTENTIONProtect the trigger from damage during transport. CAUTIONRisk of personal injury or damage! Mind the weight ofthe appliance during transport. Lay the appliance on its rear prior to transporting itand drain the residual water. Pull the device behind you at the carrying handlefor transporting it over longer distances To carry, hold the appliance by the handles and thepushing handle. When transporting in vehicles, secure the appli-ance according to the guidelines from slipping andtipping over. DANGERRisk of injury by inadvertent start-up of appliance andelectric shock. Prior to all work on the appliance, switchoff the appliance and pull the power plug. Shut off water supply. Open the hand spray gun. Switch on the pump with the power switch and al-low to run for about 5-10 seconds. Close the hand spray gun. Set the appliance switch to "0/OFF“. Pull main plug out of socket with dry hands only. Remove water connection. Activate hand spray gun until device is pressureless. Secure the trigger gun. To do so, push the safetycatch towards the front. Allow device to cool down.You can sign with your dealer a contract for regularsafety inspection or even sign a maintenance contract.Please take advice on this matter. Clean filter in the water connection. Clean filter at the detergent suck hose. Have the maintenance of the device performed bythe customer service.Note: It is not necessary to perform an oil change on thehigh-pressure pump. Remove the filter. Clean filter in water and reinstall. Clean filter in water and reinstall. DANGERRisk of injury by inadvertent start-up of appliance andelectric shock. Prior to all work on the appliance, switchoff the appliance and pull the power plug.Storing the ApplianceFrost protectionShutdownDump waterFlush device with anti-freeze agentStorageTransportCare and maintenanceSafety inspection/ maintenance contractMaintenance intervalsWeeklyMonthlyEvery 500 operating hours, at least annuallyMaintenance WorksClean filter in the water connection.Clean filter at the detergent suck hoseTroubleshooting18 EN