– 4 Connect high pressure hose and spraypipe to the hand spray gun. Tighten the screw connection of thespray lance finger tight. Install the nozzle on the spray pipe insuch a way that the marking is on the top. Tighten covering nut firmly. Connect the high pressure hose to thehigh pressure connection point of themachine.For connection values refer to technicalspecifications Connect the supply hose (minimumlength 7.5 m, minimum diameter 3/4“) tothe water connection point of the ma-chine and at the water supply point (fore.g. a tap). Open the water supply.Note: The supply hose is not included. DANGERNever suck water from a drinking watercontainer.Never suck in liquids which contain sol-vents like lacquer thinner, petrol or oil. Thespray mist of solvents is highly inflamma-ble, explosive and poisonous. Connect suction hose (minimum diame-ter 3/4“) with filter (accessory) to thewater connection point. Set dosing value for detergent to "0". Remove air from appliance before oper-ation. Open the water supply. Start the engine according to the oper-ating instructions of the engine manu-facturer. To dearate the appliance, unscrew thenozzle and allow the appliance to run untilthe water exits in a bubble-free state. Switch off the appliance and fit the noz-zle again. DANGERRisk of explosion!Do not spray flammable liquids. DANGERRisk of injury! Never use the appliancewithout the spray lance attached. Checkand ensure proper fitting of the spray lanceprior to each use. The screw connection ofthe spray lance must be finger-tight. DANGER– Place the appliance on firm surface.– The high-pressure cleaner must not beused by children. (Risk of accidents onaccount of improper use of the device).– The high-pressure jet generates highlevels of noise when the device is inuse. Risk of hearing impairment. Al-ways use proper hearing protectionwhile working with the device.– The water jet coming out of the high-pressure nozzle causes the gun to re-coil. Further, an angular spray pipe cancause additional torque. Hence, holdthe spray lance and gun firmly.– Never direct the water jet on to persons,animals, the appliance itself or electricalcomponents.– Vehile tyres/ tyre valves may becleaned only with a minimum spray dis-tance of 30 cm. Otherwise, the highpressure spray can cause damage tothe vehicle tyre/ tyre valve. The discol-ouring of the tyre is the fhe first sign ofdamage. Damaged vehicle tyres are asource of danger.– Do not spray materials containing as-bestos or other health-hazardous sub-stances.Install hand spray gun, spray lanceand nozzleWater connectionSuck in water from vessel1.2.Dearating the applianceOperation15EN