Kärcher HD 10/25 S Operating Manual

Also see for HD 10/25 S VEX: Operating instructions Operating instructions User manual Service manual

Contents

Kärcher HD 10/25 S Operating Manual Manual pdf 7 page image

– 5– Check the contents of the pack be-fore unpacking.– In case of transport damage informvendor immediately Read the oil level display when thedevice is not running. The oil levelmust be above the two pointers. Unscrew the fastening screws ofthe device hood; remove the devicehood. Cut off tip of oil container cover Fasten the device hood. Mount the nozzle on the spray pipe(markings on the adjustment ring atthe top). Connect ray tube to hand spray gun Tighten the screw connection of thespray lance finger tight. Lock in the cable hook in the side-hole on the handle. Tighten the high-pressure connec-tion as required. DangerDanger of injury by electric shock.The appliance may only be connectedto alternating current.The appliance may only be connectedto an electrical supply which has beeninstalled in accordance with IEC60364.The voltage indicated on the type platemust correspond to the voltage of theelectrical source.The minimum fuse rating required atthe socket outlet is (see technicalspecifications).The highest allowed net impedance atthe electrical connection point (refer totechnical data) is not to be exceeded.In case of confusion regarding thepower impedance present on your con-nection, please contact your utilitiesprovider.The appliance should always be con-nected to the electrical mains using aplug. It is forbidden to permanentlyconnect the appliance to the powersupply. The plug is only for mains sep-aration.Check the power cord with mains plugfor damage before every use. If thepower cord is damaged, please ar-range immediately for the exchange byan authorized customer service or askilled electrician.The plug and coupling of the extensioncable used must be watertight.Use the extension cord that has an ad-equate cross-section (see "TechnicalData") and unwind it fully from the ca-ble drum.Unsuitable extension cables can behazardous. Only use extension cablesBefore StartupUnpackingCheck oil levelActivate deaeration of oil con-tainerInstall hand spray gun, spraylance and nozzle1.2.Start upElectrical connection7EN