10 EnglishQuick connect nozzlesUSING THE ACCESSORIESWORKING WITH DETERGENTSThe color-coded quick connect nozzles provide awide array of spray widths from 0° to 65° and areeasily accessible when placed in the convenientnozzle holder.0° spray angle = Red nozzleFor particularly stubborn accumulation of grime.Not recommended for soft materials like sid-ings, decks, painted surfaces, cars.25° spray angle = Green nozzleFor dirt accumulation over a large surface.40° spray angle = White nozzleFor moderate dirt accumulation over a largesurface.65° spray angle = Black detergent nozzleFor operating with detergent or cleaning with lowpressure.WARNINGHigh pressure in nozzle area.Risk of injury caused by improperly locked nozzle.Make sure you hear a ‘click’ when inserting■the nozzle tip into the wand.Pull the nozzle to make sure it is seated■properly before operating your unit.(See ASSEMBLY INSTRUCTIONS: Step 9 )WARNINGTo avoid serious injury never point spray nozzleat yourself, other persons or animals.Detergents can only be applied with the blackdetergent nozzle.STEP 1:Install the black detergent nozzle for detergentapplication (will work at low pressureonly).STEP 2:G2600 VC - Fill a container (not included) withKärcher detergent. Place the filter end of deter-gent suction tube into the container.G2600 VC Plus - Fill the detergent tank orcontainer with Kärcher detergent.Close the de-tergent tank with the detergent metering valve.G2600 VC G2600 VC PlusSTEP 3:Adjust the detergent metering valve to the de-sired dosage. (G 2600 VC Plus only)STEP 4:With the engine running, pull trigger to operateunit.Liquid detergent is drawn into the unit and mixed withwater.Apply detergent to work area.Do not allow detergent to dry on surface.STEP 5:Always draw fresh water through the detergentsuction tube when the cleaning job is done, torinse/flush any remaining detergents from theinjection system.For best results see Cleaning Tips for specificinformation on how to clean different sur-faces.