Jet JWL-1640EVS Operating Instructions Manual

Also see for JWL-1640EVS: Operating instructions Operating instructions and parts manual

Contents

Jet JWL-1640EVS Operating Instructions Manual Manual pdf 1 page image

GB - ENGLISHOperating InstructionsDear Customer,Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has beenprepared for the owner and operators of a JET JWL-1640EVS wood lathe to promote safety during installation, operation andmaintenance procedures. Please read and understand the information contained in these operating instructions and theaccompanying documents. To obtain maximum life and efficiency from your machine, and to use the machine safely, read thismanual thoroughly and follow instructions carefully.…Table of Contents1. Declaration of conformity2. Warranty3. SafetyAuthorized useGeneral safety notesRemaining hazards4. Machine specificationsMachine descriptionTechnical dataNoise emissionContents of delivery5. Transport and start upTransport and installationAssemblyMains connectionDust collectionStarting operation6. Machine operationCorrect operating positionTool selectionSpeed selectionTurning between centresBowl turningSanding and Finishing7. Setup and adjustmentsChanging spindle speedsHeadstock spindle lockHeadstock rotationHeadstock spindle indexInstalling work holdingAdjusting tool restAdjusting tailstock8. Maintenance and inspectionAdjusting bed clampingPulley drive lubricationChanging belt and bearings9. Trouble shooting10. Environmental protection11. Available accessories1. Declaration of conformityOn our own responsibility we hereby declare that this productcomplies with the regulations* listed on page 2. Designed inconsideration with the standards**.2. WarrantyThe Seller guarantees that the supplied product is free frommaterial defects and manufacturing faults. This warranty doesnot cover any defects which are caused, either directly orindirectly, by incorrect use, carelessness, accidental damage,repair, inadequate maintenance or cleaning and normal wearand tear.Guarantee and/or warranty claims must be made withintwelve months from the date of purchase (date of invoice).Any further claims shall be excluded.This warranty includes all guarantee obligations of the Sellerand replaces all previous declarations and agreementsconcerning warranties.The warranty period is valid for eight hours of daily use. If thisis exceeded, the warranty period shall be reduced inproportion to the excess use, but to no less than threemonths.Returning rejected goods requires the prior express consentof the Seller and is at the Buyer’s risk and expense.Further warranty details can be found in the General Termsand Conditions (GTC). The GTC can be viewed atwww.jettools.com or can be sent by post upon request.The Seller reserves the right to make changes to the productand accessories at any time.3. Safety3.1 Authorized useThis wood lathe is designed for turning wood only. Machiningof other materials is not permitted and may be carried out inspecific cases only after consulting with the manufacturer.The workpiece must allow to safely be loaded and supported.The proper use also includes compliance with the operatingand maintenance instructions given in this manual.The machine must be operated only by persons familiar withits operation and maintenance and who are familiar with itshazards.The required minimum age must be observed.