Jet JWDS-2244 Assembly And Parts List

Also see for JWDS-2244: Operating instructions and parts manual

Contents

Jet JWDS-2244 Assembly And Parts List Manual pdf 1 page image

Assembly and Parts ListOpen Stand for JWDS-2244/-2550 Drum SandersIMPORTANT SAFETY INSTRUCTIONS• Read and understand entire owner's manual for your drum sander before attempting assembly or operation.• Read and understand the warnings posted on the machine and in the manual. Failure to comply with all ofthese warnings may cause serious injury.• Replace warning labels if they become obscured or removed.• Before operating, make sure the drum sander is firmly secured to the stand, and all fasteners in the standare tightened.• WARNING: This product can expose you to chemicals including lead which is known to the State ofCalifornia to cause cancer and birth defects or other reproductive harm. For more information go tohttp://www.p65warnings.ca.gov.Tools required for assembly:6mm hex (Allen) wrench12/14mm wrenches (a ratchet wrench withsockets will speed assembly time).Contents:1 Shelf – A2 Short rails – B2 Long rails – C4 Legs – D1 Hardware Package, includes:24 Carriage Bolts, M8x16 – HP124 Flanged Lock Nuts, M8 – HP24 Leveling feet – HP38 Flat washers 10mm – HP48 Hex nuts M10 – HP56 Soc. hd. cap screws M8x16 – HP68 Flat washers 8mm – HP7Assembling stand1. Assemble legs (D) to outside of Short Rails (B) with carriage bolts (HP1) and flanged lock nuts (HP2). Fingertighten only.2. Assemble Long Rail (C) on inside of legs and on top of Short Rails (B). Finger tighten only. NOTE: Flange of LongRail overlaps flange of Short Rail. See inset photo.3. Turn stand upside down. Install shelf (A) into legs using carriage bolts and flanged lock nuts.4. Insert leveling foot (HP3) into bottom hole of each leg with flat washers and hex nuts.5. Turn stand right-side up, and push down on it to settle it, then tighten all flanged lock nuts on stand.6. Level the stand by turning the leveling feet (HP3) in or out. When level, tighten hex nut (HP5) against leg flange.Mounting sander to standCAUTION: Use an assistant to help lift and position the drum sander.1. Position sander atop stand so that threaded holes of sander base align with holes in stand rails.2. Fasten sander base to stand (from beneath) with the six (6) additional screws and washers provided with the stand.3. Tighten screws securely.JET427 New Sanford RoadLaVergne, Tennessee 37086 Part No. M-723540OSPh.: 800-274-6848 Edition 2 10/2018www.jettools.com Copyright © 2018 JET, a division of JPW Industries, Inc.

/ 2

Related manuals for Jet JWDS-2244