JVC XV-S45GD Instructions Manual

Also see for XV-S30BK: Instructions Instructions Service manual Service manual

Additional information45 AdditionalinformationTroubleshootingWhat appears to be a malfunction may not always be serious. Please go through the following list before requestingservice.Symptom Possible case RemedyPower does not come on. Power plug is not inserted securely. Plug in securely.Remote control does not work.Too far from the unit. More closer to the unit.The tip of the remote unit is not pointed inthe right direction.Point the infrared light- emitting windowtoward the remote sensor on the front panel.Batteries are exhausted. Replace the batteries with new ones.Battery polarity is incorrect. Take out the batteries and insert them again inthe correct direction.No picture is displayed on themonitor.Connection of video cable is incorrect. Connect the cable correctly.Input selection of TV is incorrect. Select correctly.Disc is not playable. Use a playable disc. (See page 12.)No picture is displayed on themonitor when using theCOMPONENT or S-VIDEO outputjack(s).Jack(s) at use is (are) not active. Make them active. (See page 14.)Picture is noisy. The unit is connected to a VCR directlyand the copyguard function is activated.Connect the unit so that the picture signalflows directly to the TV.No audio is reproduced.Connection is incorrect. Check the connections.Input selection of amplifier is incorrect. Select correctly.No audio is reproduced when playingback a DVD disc recorded with 96-kHz, linear PCM audio.The audio signal is derived from the unit'sDIGITAL OUT.Use the AUDIO OUT when playing back suchdiscs.Sound is distorted or noise isgenerated. Disc is dirty. Wipe the disc surface.Picture does not fit the televisionscreen.MONITOR TYPE is not correctly set. Select monitor type correctly. (See page 37.)Television is not correctly set. Set the television correctly.Operation is not possible.Microcomputer malfunction due tolightning or static electricity.Turn off the power and unplug the powercord, then connect the power cord again.Moisture condensation caused by asudden change of temperature orhumidity.Turn off the power, then turn it on a few hourslater.