JVC XM-G6 Instructions Manual

Also see for XM-G6: Instructions

21• If “TRACK PROTECTED” appears, the selectedtrack has been write-protected by another component.You cannot edit such a protected track. To cancel theediting, press TITLE/EDIT button.5 Press SET button when you find the point where youwant to divide the track.The MD recorder repeats the selected point — a portionof three seconds length following the dividing point.• If you have selected a wrong track number, pressCANCEL button then select the correct track.6 Rotate MULTI JOG dial ( < / > button also available)to precisely adjust the dividing point.• You can shift the dividing point up to ±128. This range(±128) corresponds to approximately ±8 seconds fromthe original point (Position 0).When you stop rotating MULTI JOG dial, the systemrepeats the newly selected dividing point.7 When you find the right position, press SET button.“PUSH ENTER” appears in the display window.8 Press ENTER button to finish the editing procedures.• If you want to cancel the editing, press CANCELbutton.9 Press 0 (eject) button to eject the MD.“WRITING” appears while the editing you have madeis being recorded onto the MD.To join the divided tracks again, see the JOIN function.JOIN FunctionThis function allows you to join two adjacent tracks intoone track.• To quit any time during editing process, press TITLE/EDIT button.1 Insert an MD you want to edit into the MD loadingslot.The MD IN lamp lights orange.2 Press TITLE/EDIT button until “JOIN?” appearsin the display window.3 Press SET button.4 Rotate MULTI JOG dial to select the two adjacenttracks you want to join (< / > button also available ).5 Press SET button.• If you have selected wrong tracks, press CANCELbutton, then select the correct tracks by rotatingMULTI JOG dial (< / > button also available).• If you want to cancel the editing, press TITLE/EDITbutton.• If “TRACK PROTECTED” appears, the selectedtrack has been write-protected by another component.You cannot edit such a protected track. To cancel theediting, press TITLE/EDIT button.6 Press ENTER button to finish the editingprocedures.7 Press 0 (eject) button to eject the MD.“WRITING” appears while the editing you have madeis being recorded on the MD.To divide the joined tracks, see the DIVIDE function.Continued