JVC XM-448BK Instructions Manual

Also see for XM-448BK: Instructions

205 Fine-adjust the track marking position.Turn the jog dial on the main unit or press < / 4 or ¢ / > on the remote controlunit.The track marking position can be fine-adjusted in the range of ±128 positions (approx.±8 sec.).As you adjust, the track marking is displaced slightly and the 4-second section from thenewly divided point will be played repeatedly.• After completing the fine-adjustment, go to step 6.• To cancel the current track marking position, press 7STOP/CANCEL on the mainunit or CANCEL on the remote control unit and repeat from step 3.6 Press ENTER on the main unit or on the remote controlunit.The change made above is enteredtemporarily in memory. The display shows“EDITING” and the TOC indicator lightsup.TOC indicator:The TOC indicator shows that the MD has new data that should be memorized.The data writing operation is done by ejecting the MD or by turning the power off.Before the MD is ejected or the power is turned off, “UTOCwriting” is displayed untilthe data is completely written.7 Press 0 on the main unit or on the cover panel of theremote control unit to eject the MD.The data in memory is written in the MD before it is ejected.The display shows “UTOCwriting” during MD writing operation.• Be careful not to apply impact to the MD recorder during writing temporarily storeddata into the MD. Otherwise the recording may not be able to play later.• The data in memory is written in the MD also when the power is turned off while“EDITING” is being displayed.To cancel editing:Press EDIT repeatedly on the main unit or on the remote control unit before pressingENTER in step 6.To restore the original track from the divided tracks:Use the JOIN editing function mentioned below.Joining tracks (JOIN)Two adjacent tracks can be joined into a single track by deleting an unnecessary trackmarking. This also makes it possible to join more than two tracks into a single track or apiece of music divided into multiple tracks into a single piece. The track numbers after thejoined tracks are renumbered automatically.1 Press EDIT on the main unit or on the remote control unitto select “JOIN”.The JOIN indicator lights up.Each press of the button switches the editing functions as follows.BlinksOROR ENTER71 2 3 4 56ORDIVIDE JOIN MOVECanceled(MD total playing time display or Disc title)ERASE ALL ERASEOR EDIT1 2 3 4 56