JVC VN-T16U Quick Manual

Also see for VN-T16U: Specifications Instructions Specifications Instructions Quick guide

Contents

21 IntroductionThank you for purchasing the camera. Before installing it, please verify your model and read this guide carefully. See theINSTRUCTIONS located on CD-ROM for more information about setting up your camera.Unpack Everything• HD IP CAMERA• WARRANTY CARD• SAFETY PRECAUTIONS• QUICK GUIDE• 8-PIN TERMINAL BLOCK for alarm input/output• CD-ROM containing INSTRUCTIONS and IP Finder softwarePrepare for InstallationSelect the lens to use with your camera. This camera supports the use of a manual iris or DC irislens . When using a DC iris lens, it should be connected to the camera via the 4-pin square socketlocated at the side of the camera.Mount the Camera1. Attach the camera to a pending mount.Insert the screws on the camera stand into either of the screw holes on the base. Then tightenthem up.2. Mount the camera onto the ceiling/wall and fasten it securely.3. Connect the Safety Wire(Fall Prevention Wire, not supplied) to the camera and the wall/ceiling.To prevent the camera from falling off, ensure that it is connected to a firm place(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is notsupplied).Warning Pay also careful attention to the length, strength, wiring, and material (insulatingproperties) of a Safety Wire (fall prevention wire) to be used. The length shouldbe as short as possible within the permissible range of the mounting length. Thewire should be strong enough to withstand the total weight of this product and thefixer. (Pay also attention to the finishing at the end of the wire.)Caution Must be isolated camera and the wall/ceiling which are connected by a SafetyWire (Fall Prevention Wire).