E-141234Cap (Upper)1-1 Connecting Cables (Continued)3. Lead the cable through the coverMake a slit on the (rubber) cap that is attachedto the cover, followed by leading the cablethrough. See diagram on the left on how tomake the slit.4. Connect the cable to this cameraConnect cables to the terminal on the ceilingmount. Connection cables include alarmsignal cable, LAN cable, coaxial cable and thatfor the Converter Unit.1 Alarm signal cable (☞Page 15)Connect this cable to devices with alarminput/output terminals.2 LAN cable (☞Page 16)Connect this cable to a hub or PC.3 Coaxial cable (☞Page 17)Connect this cable to NTSC monitors.4 Converter Unit (☞Page 18)Connect this to a DC12V power supply.5. Attach the coverAttach the cover to the ceiling mount byfollowing procedure of Step 2 in the reverseorder.1 Attach the cover upon aligning the hole withthe safety wire mounting hole on the ceilingmount, followed by turning it in theclockwise direction.2 Fasten the cover fastening screw.Preparation (Step 1 Connection/Installation)
