(For USA and Europe)v The unit is to be powered by a DC 12 V or an AC 24 V power supply.v The unit is to be powered by a UL Listed DC 12 V or an AC 24 Vpower supply. (For USA)v The AC 24 V and 12 V DC power supply shall conform to thefollowing: Class 2 only (For USA), Isolated power supply only (ForEurope).v This installation should be made by a qualified service person andshould conform to all local codes.v This installation shall be in accordance with the National ElectricalCode, ANSI/NFPA 70.v Any Mention in this manual of Alarm inputs have not been evaluatedby UL to be used for Burglar Alarm Functionality.v Special technique is required when installing this product. Pleaserefer to your dealer for installation.v Rating label is pasted on of the camera unit.v JVC KENWOOD Corporation is not liable for any compensation if youdrop the camera due to insecure mounting by not following theinstallation description. Pay careful attention during installation.v When mounting this product to a ceiling or wall, select a locationstrong enough to support the weight of this camera. If the location isnot strong enough to support the weight, be sure to reinforce theceiling or wall before installation.v The camera may drop if the mounting screws are not tightenedsecurely. Check that the screws are tightened appropriately andsecurely.v Do not install the camera near lighting fixtures of high temperature,such as spot lights. It might result in failure or fires.v Do not step on or hang on the camera. Doing so may cause thecamera to fall, and break, which would cause injuries.IntroductionE-9