JVC TK-C750 Instructions Manual

Also see for TK-C750: Instructions Instructions Instruction manual Instructions Instructions

IMPORTANT SAFEGUARDS1. Read all of these instructions.2. Save these instructions for later use.3. All warnings on the product and in the operating instructions should be adhered to.4. Unplug this appliance system from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.Use a damp cloth for cleaning.5. Do not use attachments not recommended by the appliance manufacturer as they may cause hazards.6. Do not use this appliance near water - for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wetbasement, or near a swimming pool, etc.7. Do not place this appliance on an unstable cart, stand, or table. The appliance may fall,causing serious injury to a child or adult, and serious damage to the appliance may fall,causing serious injury to a child or adult, and serious damage to the appliance.Use only with a cart or stand recommended by the manufacturer, or sold with the appliance.Wall or shelf mounting should follow the manufacturer’s instructions, and should use a mountingkit approved by the manufacturer.An appliance and cart combination should be moved with care. Quick stops, excessive force,and uneven surfaces may cause the appliance and cart combination to overturn.8. Slots and openings in the cabinet and the back or bottom are provided for ventilation, and toinsure reliable operation of the appliance and to protect it from overheating, these openingsmust not be blocked or covered. The openings should never be blocked by placing the appliance on a bed, sofa,rug, or other similar surface. This appliance should never be placed near or over a radiator or heat register. Thisappliance should not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.9. This appliance should be operated only from the type of power source indicated on the marking label. If you arenot sure of the type of power supplied to your home, consult your dealer or local power company. For appliancedesigned to operate from battery power, refer to the operating instructions.10. This appliance system is equipped with a 3-wire grounding type plug (a plug having a third (grounding) pin). This plugwill only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into theoutlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding plug.11. For added protection for this product during a lightning storm, or when it is left unattended and unused for longperiods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will preventdamage to the product due to lightning and power-line surges.12. Do not allow anything to rest on the power cord. Do not locate this appliance where the cord will be abused bypersons walking on it.13. Follow all warnings and instructions marked on the appliance.14. Do not overload wall outlets and extension cords as this can result in fire or electric shock.15. Never push objects of any kind into his appliance through cabinet slots as they mat touch dangerous voltagepoints or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance.16. Do not attempt to service this appliance yourself as opening or removing covers may expose you to dangerousvoltage or other hazards. Refer all servicing to qualified service personnel.17. Unplug his appliance from the wall outlet and refer servicing to qualified service personnel under following conditions:a. When the power cord or plug is damaged or frayed.b. If liquid has been spilled into the appliance.c. If the appliance has been exposed to rain or water.d. If the appliance does not operate normally by following the operating instructions. Adjust only those controls thatare covered by the operating instructions as improper adjustment of other controls may result in damage andwill often require extensive work by a qualified technician to restore the appliance to normal operation.e. If the appliance has been dropped or the cabinet has been damaged.f. When the appliance exhibits a distinct change in performance - this indicates a need for service.18. When replacement parts are required, be sure the service technician has used replacement parts specified by themanufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire,electric shock, or other hazards.19. Upon completion of any service or repairs to this appliance, ask the service technician to perform routine safetychecks to determine that the appliance is in safe operating condition.TK-C750/TK-C751These instructions are for TK-C750U, TK-C750E and TK-C751EG Information for USAThis device complies with Part 15 of the FCC Rules.Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.For Customer Use:Enter below the Serial No. which is located on the body.Retain this information for future reference.Model No.Serial No.®The lightning flash with arrowhead symbol,within an equi-lateral triangle, is intended toalert the user to the presence of uninsulated“dangerous voltage” within the product’s en-closure that may be of sufficient magnitudeto constitute a risk of electric shock to per-sons.The exclamation point within an equilateral tri-angle is intended to alert the user to the pres-ence of important operating and maintenance(servicing) instructions in the literature ac-companying the appliance.For USA and CANADACAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.DO NOT REMOVE COVER (OR BACK).NO USER SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENINFORMATION (FOR CANADA) RENSEIGNEMENT (POUR LE CANADA)This Class [B] digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.PORTABLE CART WARNING(symbol provided by RETAC)S3125ACOLOR VIDEO CAMERA InstructionsThank you for purchasing the JVC color video camera.To obtain the best results from your new camera, read these instructions carefully before use;retain the manual for future reference.WARNING:TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOIS-TURE.PRECAUTIONS• This unit incorporates the AGC (Auto Gain Control) function, which increases the sensitivityautomatically in dark places. It is not a malfunction when the image looks grainy in dark conditions.• Before mounting the camera, first mount the lens to be used with the camera, and then operateit in order to check the back focus.• If a high-intensity object (such as a lamp) is in shot, the image on the screen may have verticallines (smear) or blur (blooming) at its periphery (especially in AES mode). This is a characteristicof the CCD, and is not a defect.• If an EE lens is used, set the automatic electronic shutter switch (AES) to OFF. If set to ON,flickering may occur. If a manual iris lens is used, set the AES to ON.• When used in hot places, vertical lines may appear on the screen of this camera. This is acharacteristic of the CCD and not a failure of the camera.• The automatic tracking system may not function properly when shooting with non-standardlighting or lighting with a color temperature which exceeds the capability of the camera.• If the camera subject is a single solid color (other than white), the auto white circuit will normallyattempt to change this color to white. In the case of this camera, if it cannot make a correctprediction, the previous white balance setting will be maintained until the subject colors becomemore varied.• This unit assumes that the light source being used is either natural lighting (sunlight) orincandescent lamps (color temperature 2300 K-10000 K). Under special light sources, such assodium lamps, colors may appear different compared to what is visible to the eye.• Noise may appear in the picture and/or the colors may be incorrect if the camera is used near aradio or television transmitting antenna, in places where strong electromagnetic waves aregenerated by transformers, motors, etc., or near devices emitting radio waves, such astransceivers or cellular phones.• This unit accepts only a DC iris lens.• To save energy, be sure to turn off the system when not in use.MOUNTING A LENS1. Before mounting a lens, check whether it is a C-mount or CS-mount lens.If a C-Mount lens is used, loosen the back-focus locking screw (M 2.6) using a Phillipshead screwdriver, turn the back-focus adjusting ring with your fingers or the screw-driver and change the mounting method.2. Dimension (b) of the lens shown in the illustration must be as shown in the tablebelow. If (b) exceeds the value in the table, it may damage the inside of the cameraor correct mounting may be impossible; never use such lenses. Do not attach a C-mount lens when using the CS-mount.The F mark indicates a focal point.3. Mount the DC IRIS lens on the camera by turning the lens clockwise. Adjust itsposition.4. If the lens has an auto-iris mechanism, connect the lens cable after checking the pinassignment.*4 pin plug, service part number: SCV2859-001For details, please consult your JVC dealer.CONNECTION1. When the camera is powered, the POWER LED lights up.∆A∆B∆C∆D∆E∆F(b)(c)FA BIRISL HLEVELCOLOR VIDEO CAMERAC DMAX.7 mm(f)IRISL HLEVELCOLOR VIDEO CAMERAIRISL HLEVELCOLOR VIDEO CAMERA4mmE Fqew(d)(e)1 342Lens Flange back (c) Dimension (b)C mount lens 17.526 mm 10 mm or lessCS mount lens 12.5 mm 5.5 mm or lessLens DC IRISPin No. (does not contain EE amplifier)1 Brake –2 Brake +3 Drive + [Voltage: 0.45 V – 4.05 V]4 Drive – Current: max. 26 mA2. Connect to a video monitor, etc. (75 )3. When mounting the camera on a fixer, pan/tilt, etc., use the camera mounting screwhole (d) located on the camera-mounting bracket.CAUTION: Use a screw shorter in length than 7mm from the camera-mountingface.Furthermore, make use of the rotation prevention holes (e) to prevent the camerafrom falling and be sure to mount the camera securely.Special precautions must be taken when mounting the camera on a wall or a ceiling.JVC is not liable for any damage caused by incorrect installation.4. Installation of camera• With the mounting plate on the undersideThis camera is originally designed to be mounted from underneath, as shown q.The hole is standard photographic pan-head screw size (1/4-20 UNC, as is foundin a typical camera fixing point or pan & tilt head.• With the mounting plate relocated to the topsideRemove the CAMERA MOUNTING BRACKET (f) from the underside of the cameraby removing the two fixing screws as shown w. Attach the CAMERA MOUNTINGBRACKET (f) to the top, then mount the camera on the Fixing Unit as shown e.Make sure that two original screws are used when mounting the CAMERAMOUNTING BRACKET (f). Be sure to use a 6 mm long locking screw for the camera-mounting bracket.These instructions assume the camera will only be mounted indoors.Fall Prevention• Exercise maximum caution when installing the unit to a wall or ceiling. If in any doubtask a professional to do the job, because if the unit were subsequently to fall, it couldresult in personal injuries or accidents.• When installing the unit on a fixer, turn table, etc., be sure to install it firmly and touse one of the rotation-preventing holes (e) provided.• As a failsafe against falling, attach the unit by chain, wire cable or other safety restraint toan appropriate anchor point. Attach the fall prevention wire using the black screw on theupper surface (TK-C751 : on the rear panel) of the camera as shown in figure F. Whenchanging the side at which CAMERA MOUNTING BRACKET is installed, be sure tochange the attachment side of the fall prevention wire also to the appropriate side.• Specified screw (TK-C750 : M2.6 4 mm, TK-C751 : M3 6 mm )Never use any screw longer than the specified length as the inside can be damaged.CAMERA type powerTK-C750U AC 24 V ` (class 2 only)TK-C750E AC 24 V ` (isolated power only)TK-C751EG AC 220 V to 240 V ` (The power cable is 2500 mm in length.)EG onlyWhen you use this camera, the socket - outlet must be installed near the equip-ment to make disconnect on easily.VIDEO OUTSEE INSTRUCTIONMANUALPOWERRESETSETOFFOFFATWLLINTAWBON-BLCON-AES6mm2mmPHASETK-C750TK-C751All manuals and user guides at all-guides.comall-guides.com

/ 2

Related manuals for JVC TK-C750