JVC SR-MV45US - SR MV45U Read This First Manual

Also see for SR-MV45U: Instructions

Read This First● When the AC plug is connected into AC outlet for the first time “LOADING” is displayed forapproximately 50 seconds while microprocessor is being initialized. Make sure to startoperations only after “LOADING” disappears from the front display panel.● When switching to the DVD mode with the VC-VDV 204U cable (IEEE 1394 cable)connected, the TV screen may appear all blue or black. To avoid this, re-connect the VC-VDV204U cable.In addition, when performing IEEE 1394 connection, be sure to do as follows.1. Switch the unit to DVD mode.2. Set the unit’s input to “DV”.3. Connect the VC-VDV 204U cable.● If the unit malfunctions, please reset the unit by pressing and holding “STOP” and“OPERATE” buttons together until “LOADING” starts blinking on the front display panel orsimply reset AC power.● Contact Detail For Customer SupportUS Customer onlyNEED HELP ON HOW TO CONFIGURE YOUR SYSTEM?NEED ASSISTANCE ON HOW TO OPERATE?NEED TO LOCATE A JVC SERVICE CENTER?LIKE TO PURCHASE ACCESSORIES?1(800)582-5825http://www.jvc.com/proENGLISHLPT1145-002A1206MNH-SW-BJ(SR-MV45U/55U)

/ 1

Related manuals for JVC SR-MV45U