JVC RX-D301S Instructions Manual

Also see for RX-D301S: Instructions Instructions Instructions Service manual Service manual

Contents

5Snap the tabs on theloop into the slots ofthe base to assemblethe AM loop antenna.Connecting the FM and AM antennasDo not connect the AC power plug to the wall outlet until all connections are completed.AM loop antenna(supplied)If AM reception is poor, connectan outdoor single vinyl-coveredwire (not supplied).AM antenna connectionConnect the AM loop antenna supplied to the AM LOOP terminals.Connect the white cord to the AM EXT terminal, and connect theblack cord to the H terminal.Turn the loop until you have the best reception.• If the reception is poor, connect an outdoor single vinyl-coveredwire (not supplied) to the AM EXT terminal. Keep the AM loopantenna connected.FM antenna connectionConnect the FM antenna supplied to the FM 75 Ω COAXIALterminal as a temporary measure.Extend the supplied FM antenna horizontally.• If the reception is poor, connect an outdoor FM antenna (notsupplied). Before attaching a 75 Ω coaxial cable with aconnector, disconnect the supplied FM antenna.FM antenna (supplied)NOTES• If the AM loop antenna wire is covered with vinyl,remove the vinyl while twisting it as shown on theright.• Make sure the antenna conductors do not touchany other terminals, connecting cords and powercord. This could cause poor reception.If FM reception is poor, connect anoutdoor FM antenna (not supplied).ANTENNACOAXIALFM 75AM EXTAM LOOPANTENNA