JVC RX-7040B Instructions Manual

Also see for RX-7042S: Instructions Service manual

Contents

17Turning Analog Direct On and OffYou can enjoy the sound closer to the original source by overridingthe sound adjustments such as Midnight Mode (see page 16), BassBoost (see page 18), Equalization pattern (see page 28), speakeroutput level adjustments (see page 28), and Surround and DSPmodes (see pages 30 to 35). You can only adjust the volume leveland the subwoofer output level while Analog Direct is in use.• Once you have made an adjustment, it is memorized for eachanalog source.Press ANALOG DIRECT so that “A DIRECT” appears on thedisplay.The lamp on the button also lights up.• Each time you press the button, Analog Direct turns on and off(the lamp goes off) alternately.Notes:• When digital input mode is in use, Analog Direct is not available.• Turning on Surround or DSP mode cancels Analog Direct andpreviously selected sound adjustments are recalled.• If Analog Direct is in use, Midnight Mode (see page 16) istemporarily canceled.• Turning on Analog Direct cancels Input Attenuator (see page 16)and CC Converter (see below).Making Sounds NaturalJVC’s CC (Compensative Compression) Converter eliminates jitterand ripples, achieving a drastic reduction in digital distortion byprocessing the digital music data in 24 bit-quantization and byexpanding the sampling frequency to 128 kHz (for fs 32 kHzsignals)/176.4 kHz (for fs 44.1 kHz signals)/192 kHz (for fs 48 kHzsignals) on the front speakers.By using CC Converter, you can obtain a natural sound field fromboth digital and analog sources.Press CC CONVERTER so that the lamp on the button lightsup.• Each time you press the button, CC Converter turns on and off (thelamp goes off) alternately.Note:You cannot use this function while Analog Direct is in use. If you turnon Analog Direct while this function is in use, this function will becanceled.LINEAR PCML RANALOGVOLUMESPEAKERS 1Changing the Source NameWhen you have connected a CD recorder to the TAPE/CDR IN jacksor a DBS tuner to the TV SOUND/DBS IN jacks on the rear panel,change the source name which will be shown on the display.When changing the source name from TV to DBS:1. Press TV SOUND/DBS.• Make sure “TV” appears on the display.2. Press and hold TV SOUND/DBS until “ASSGN DBS”appears on the display.Note:When connecting a DBS tuner to the TV SOUND/DBS IN jacks,change the source name to DBS, which will be shown on the displaywhen selected as the source. Otherwise, you cannot view any picturefrom DBS tuner.When changing the source name from TAPE to CDR:1. Press TAPE/CDR.• Make sure “TAPE” appears on the display.2. Press and hold TAPE/CDR until “ASSGN CDR” appears onthe display.To change the source name to TV and TAPE, repeat the sameprocedure above.Note:Without changing the source name, you can still use the connectedcomponents. However, there may be some inconvenience.– “TAPE” or “TV” will appear on the display when you select the CDrecorder or DBS tuner.– You cannot use the digital input (see pages 15 and 16) for the CDrecorder.RemoteNOT