JVC RX-7032VSL Instructions Manual

Also see for RX-7032VSL: Instructions Instructions Instructions Instructions Instruction manual

Contents

40EnglishAV COMPU LINK Remote Control SystemThe AV COMPU LINK remote control system allows you to operate JVC’s video components (TV, VCR, and DVD player)through the receiver.This receiver is equipped with the AV COMPU LINK-III, which adds a function to the previous version in order to operate JVC’s videocomponents through the video components terminals. To use this remote control system, connect the video components you want to operate,following the diagrams below and the procedure on the next page.CONNECTIONS 1: AV COMPU LINK ConnectionCAUTION:You can only connect to the TVwith the AV COMPU LINK EX orAV COMPU LINK-III jack.DO NOT connect to the TV withAV COMPU LINK RECEIVER/AMP jack.IMPORTANT:The AV COMPU LINK remote control system cannot control the DBS tuner.Notes:• When connecting the receiver and a TV with the AV COMPU LINK EX terminal by using a component video cable, you cannot use automaticselection of TV’s input mode (see page 41).• When connecting only the VCR or DVD player to this receiver, connect it directly to the receiver using cables with the monaural mini-plugs.CONNECTIONS 2: Video Cable ConnectionThis receiver is equipped with three types of the video terminals—S-video, composite video, and component video, and the signals cominginto this receiver through one type of video jacks can output only through the jack of the same type. So you need to connect the VCR and/orDVD player to the TV using one of the following three ways:• When using the AV COMPU LINK remote control system, set the component video input for the DVD player and the DBS tunercorrectly (see “Setting the Component Video Input” on page 28); otherwise, the correct input for this receiver will not be selected on theTV.CASE 1 When connecting the source equipment to the receiver through the S-video jacks, connect this receiverto the TV’s Video Input 1 jack using S-video cables.CASE 2 When connecting the source equipment to the receiver through the composite video jacks, connectthis receiver to the TV’s Video Input 2 jack (composite video input) using composite video cables.CASE 3 When connecting the source equipment to the receiver through the component video jacks, connectthis receiver to the TV’s Video Input 2 jack (component video input) using component video cables.Sourceequipment RX-7032VSL TVTo Video Input 1S-video cordS-video cordSourceequipment TVTo Video Input 2Compositevideo cordCompositevideo cordSourceequipment TVTo Video Input 2Componentvideo cordComponentvideo cordAVCOMPULINK-AVCOMPU LINKVHSAVCOMPU LINK AVCOMPU LINK EXDVDAVCOMPU LINK-ΙΙΙVCR DVD player TVRX-7032VSLRX-7032VSL