JVC LYT1053-001B Instructions Manual

Also see for DZ-VCA3U - 3-ccd Micro Hdtv Camera: Instructions Specifications

Contents

11Camera control unit (rear panel)1 Lens mount ringStandard C mount is used.Flange back will be 17.526mm in air.2 Camera cable connector (plug)Connect to camera control unit.Camera head~AC INNTSC OUT SXGA OUTGBRDV YPBPRY/C(S)VBSHD OUTGENLOCKIN/OUT6 75312421 [AC INPUT] power input connectorTo input AC120V.2 Equal-potential connector3 Cover for extension slotRemove the cover to install an optional device inthis slot.4 [NTSC OUTPUT] NTSC output sectionOutput of DV signals, Y/C(S) signals, VBS (compos-ite video signals).The power supply for IEEE1394 interface is notavailable from DV connector.5 [GENLOCK IN/OUT] sync signal input/outputInput/output of composite sync signal for externalsync. (menu-based switching).6 [SXGA OUT] SXGA output sectionOutput of progressive scan GBR signal.SXGA output signal cannot be displayed on the DT-V1900CG.Use the monitor that is compliant with thefollowing scanning frequency.Horizontal: 67.4325kHz, vertical: 59.94Hz7 [HD OUT] video signal output sectionOutput of HD (Y, P B , PR) video signals (interlacescan).When HD video signals are connected to Hi-visionmonitor, the screen will have a width/length ratio of16:9, and the picture will extend sideways.