JVC LT-49K880 Quick Start Manual

Also see for LT-49K880: Instruction manual

• Do not connect the TV to the mains supply until you have completed all the connections.• Always disconnect the TV from the mains socket when not in use for a long period of time.• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.To completely disconnect the mains power, please remove the mains plug from the mains socket.The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time becausethe screen could crack.Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.TVTV Stand NeckTV Stand BaseRemote Control/AAA Batteries x2Screws x 8Instruction ManualQuick Start GuideUnpacking11. Connect one end of the RF coaxial cableto the aerial socket on the wall and theother end of the cable to the ANT socketon the back of your TV.2. Plug the TV into a mains socket andswitch on at the mains.3. In standby mode, press the button onthe remote control to turn the TV on. TheLED indicator will flash for a few secondsthen the TV will switch on.Connecting the Aerial and Turning on the TV4Installing the Stand31. Slide open the battery compartment on the back of the remote control.Operating Your Remote Control2Thank you for purchasing your new JVC TV.Your new TV incorporates the latest technology to enhance your viewingexperience. We would suggest that you allow about 20 mins for initial setup.Please follow this guide for a successful first time installation.The latest eco-friendly power-saving technology will switch off the TV ifit is left on and idle for 4 hours. Please refer to “Auto Standby” under the“Time Settings” section of the instruction manual for more detail.Quick Start Guide49" LED Smart 4K HDR TVLT-49K8802. Insert two AAA size batteries. Make sure to match the (+) and ( - )ends of the batteries with the (+) and ( - ) ends indicated in the batterycompartment.3. Slide the battery compartment cover back into place. Make sure it clicksinto place.OptionalIf you want to connect to the internet via a wired connection thenconnect your ethernet cable to the LAN socket.HDMI3HDMI 2 (ARC)LANANT.VGAOptic.OUTSPDIFLNB300mA Max.13V dc/18V dcRF coaxial cable(not included)RF coaxial cablewith ‘F Type’ connector(not included)Fitting the Stand to the TV3. Ensure the TV is switched off and not connected to the mains power supply.4. Lay the TV down on a flat surface ideally on the edge of a table so the base of theTV slightly overhangs the edge of the table, with the back side facing up. Pleasemake sure a soft cushioned material (such as a dry bath towel or thick piece offoam) is placed beneath the screen.5. Slide the stand under the lip, the neck will fit snugly over the screw holes. Thenscrew the stand to the TV using the 4 screws supplied.Fitting the Stand Neck and Base Together1. Fit the neck onto the base.2. Using 4 of the supplied screws, screw the neck to the base.Slide underthe lipSCARTSPDIFOptic.OUTVGAANT.HDMI 1(ARC)HDMI 2HDMI 3LANTableCushionedmaterialProtectiveBagJVC 49' LED Smart 4K HDR TV LT-49K880 Quick Start.indd 1 05/02/2018 15:05

/ 2

Related manuals for JVC LT-49K880