JVC LT-32C660 Instruction Manual

Also see for LT-32C660: Quick start guide Quick start guide

Contents

102 PreparationUnpacking the TVRemove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.The following items are included:Thank you for purchasing your new JVC TV.Your new TV has many features and incorporates the latest technology to enhance your viewingexperience. We recommend that you spend some time reading this instruction manual so that you fullyunderstand these features. You will also find some hints and tips to help you resolve any issues.Read all the safety instructions carefully before use and keep this instruction manual for future reference.Chapter2Remote Control /AAA Batteries x 2Stand screws x4Instruction Manual Quick Start GuideInstruction Manual32" LED Smart HD TVLT-32C660/661(A)GBSCARTSPDIFOptic.OUTVGAANT.HDMI 1(ARC)HDMI 2LANSCARTSPDIFOptic.OUTVGAANT.HDMI 1(ARC)HDMI 2LANRF coaxial cable(not included)Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.TVTV StandScrews x 4Remote Control/AAA Batteries x2Instruction ManualQuick Start GuideUnpacking11. Slide open the battery compartment on the back of the remote control.Operating Your Remote Control2Thank you for purchasing your new JVC TV.Your new TV incorporates the latest technology to enhance your viewingexperience. We would suggest that you allow about 20 mins for initial setup.Please follow this guide for a successful first time installation.The latest eco-friendly power-saving technology will switch off the TV ifit is left on and idle for 4 hours. Please refer to “Auto Standby” under the“Time Settings” section of the instruction manual for more detail.Quick Start Guide32" LED Smart HD TVLT-32C660(A) / LT-32C661(A)2. Insert two AAA size batteries. Make sure to match the (+) and ( - )ends of the batteries with the (+) and ( - ) ends indicated in the batterycompartment.3. Slide the battery compartment cover back into place. Make sure it clicksinto place.• Do not connect the TV to the mains supply until you have completed all the connections.• Always disconnect the TV from the mains socket when not in use for a long period of time.• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.To completely disconnect the mains power, please remove the mains plug from the mains socket.The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time becausethe screen could crack.1. Connect one end of the RF coaxial cable to the aerial socket on the walland the other end of the cable to the ANT socket on the back of your TV.2. Plug the TV into a mains socket and switch on at the mains.3. In standby mode, press the button on the remote control to turn theTV on. The LED indicator will flash for a few seconds then the TV willswitch on.Connecting the Aerial and Turning on the TV4Fitting the Stand to the TV1. Ensure the TV is switched off and not connected to the mains power supply.2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the backside facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand to the TV using the 4 screws supplied.Installing the Base Stand3Slide underthe lipSlide underthe lipSCARTSPDIFOptic.OUTVGAANT.HDMI 1 (ARC)HDMI 2LANTableCushionedmaterialOptionalIf you want to connect to the internet via a wired connectionthen connect your ethernet cable to the LAN socket.LT-32C660/661(A)_QSG.indd 1 06/09/2016 17:36SUBT.LANG.TXTMENUQ. MENUEXITBACKOK6 MNO9 WXYZ0TV7 PQRS 8 TUV4 GHI 5 JKL.,/@ 2 ABC 3 DEFV PEPGTVTV StandLT-32C660/661(A)_IB.indd 10 06/09/2016 18:11