JVC KD-NX901 Service Manual

Also see for EXAD KD-NX901: Instructions Service manual Installation & connection manual

Contents

1-24 (No.MA161)3.2.10 Removing the DVD pickup assembly(See Figs.18 to 20)• Remove the mechanism control board.(1) From the bottom of the body, turn the feed gear in the di-rection of the arrow to move the DVD pickup outwards.(See Fig.18)(2) Remove the screw J attaching the thrust spring. (SeeFig.18)(3) Remove the DVD pickup assembly upward on the L.S.gearside and release from sub shaft at joint s Move the leadscrew of the DVD pickup assembly in the direction of thearrow to release from joint t. (See Fig.19)Caution:• When releasing the lead screw at joint t, the L.S.collarcomes off at the end of the lead screw.When reassembling, reattach the L.S.collar to the leadscrew and engage joint t. (See Fig.19)• When reattaching the L.S.collar, reattach it to the points of the lead screw, and to the rod (M).Make sure that the L.S.collar is set on the rod (M)spring. (See Fig.19)(4) Remove the screw K attaching the rack spring and rackplate on the DVD pickup. (See Fig.20)(5) Pull out the lead screw. (See Fig.20)Caution:Perform adjustment after replacing the pickup.Fig.18Fig.19Fig.20JFeed gearThrust springDVD Pickup assemblytsL.S.collarRod(M)L.S.gearLead screwSub shaftDVD Pickup assemblyKRack springRack plateL.S.collarDVD PickupLead screw