JVC KD-AVX33 Installation & Connection Manual

Also see for Exad KD-AVX33: Instruction manual Instructions Installation & connection manual Instructions Instruction manual

Contents

1KD-AVX33Installation/Connection ManualThis unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle doesnot have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.WARNINGS• DO NOT install any unit and wire any cable in locations where;– it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident.– it may obstruct the operation of safety devices such as air bags, as this may result in a fatal accident.– it may obstruct visibility.• DO NOT operate any unit while manipulating the steering wheel, as this may result in a traffic accident.• The driver must not watch the monitor while driving. If the driver watches the monitor while driving, itmay lead to carelessness and cause an accident.• The driver must not put on the headphones while driving. It is dangerous to shut off the outside soundswhile driving.• If you need to operate the unit while driving, be sure to look around carefully.• If the parking brake is not engaged, “Parking Brake” appears on the monitor, and no playback picturewill be shown.– This warning appears only when the parking brake lead is connected to the parking brake system builtin the car.Notes on electrical connections:• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audiodealer.• It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rearand at the front, with an impedance of 4 Ω to 8 Ω).If the maximum power is less than 50 W, change “Amplifier Gain” setting to prevent the speakers frombeing damaged (see page 51 of the INSTRUCTIONS).• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.QRubber cushionGCrimp connectorsNWasher (ø5)oLock nut (M5)RMounting bolt—M5 x 20 mmPHandlesIBatteries* 1 When you stand the unit,be careful not to damagethe fuse on the rear.Do the required electrical connections.Bend the appropriatetabs to hold the sleevefirmly in place.Heat sinkMReverse gear signal extension cordDo not block the fan.INSTALLATION (IN-DASH MOUNTING)The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.• If you are not sure how to install this unit correctly, have it installed by a qualified technician.• Make sure not to block the fan on the rear panel to maintain proper ventilation when installed.• You cannot install the unit on the car which has any obstacles in the space shown in “Required space for installation” above.Required space for installationControl panel5 mm5 mmKMicrophoneLMicrophone clipInstalling the remote controllerHRemote controller / HolderTrim plate is detached on thisillustration for explanation.LVT1708-004A[A] 0207MNMMDWJEINEN©2007 Victor Company of Japan, LimitedFAudio/video cordParts list for installation and connectionThe following parts are provided for this unit. After checking them, please set them correctly.DashboardCSleeveEPower cordA / BHard case/Control panelDTrim plateJDouble-sidedadhesive tapeDouble-sidedadhesive tapeHolderRemote controllerFit the protrusionsoutside the unit.Caution when installingFit the unit into the mounting sleeve by using four corners of the trim plate.• DO NOT press the panel (shaded in the illustration).

/ 4

Related manuals for JVC Exad KD-AVX33