JVC HR-XVC20U User Manual

Also see for HR-XVC20US: Service manual Service manual

Contents

23Auto clock settingThe Auto Clock feature enables the automatic clock setting and updating, and also to set the Time Zoneand Daylight Saving Time by receiving XDS (Extended Data Service) information carried on the channelsignal.Press SET UP MENU. The VCR menu screen will appear.Press or to select the “SYSTEM SETUP” menu, thenpress ENTER.2 Press or to select the“STANDARD TIME” option, thenpress ENTER.After Auto Clock setting, in some casethe clock may display the other timezone’s. You can correct the clock byselecting your Time Zone settingabove.When the clock is not set or you setthe clock manually, Time Zone settingis not available.NOTES:You must set the antenna connection before the AC cord plug isinserted into the AC outlet.Make sure the AUTO CH MEMORY (on page 21) is done.1Preparation:Auto clock settingWAIT 30 MINUTES! when the power switch is off, after theconnections of the antenna and the power plug. Because the AutoClock setting feature is activate.After the clock is set automatically, you may have to set the TimeZone and Daylight Saving Time.Press POWER to turn on the DVD/VCR after the Auto Clock operationcompleted.When shipped from factory, the AUTO CLOCK option is set to ONposition.The Auto Clock setting will be performed at 6:00 AM, 12:00 PM and6:00 PM everyday when the DVD/VCR is turned off.If you turn the DVD/VCR on during Auto Clock setting, the clock is not set.With cable box connection, if the Auto Clock Setting is unsuccessful,please select the PBS channel carrying the XDS information, then turnthe DVD/VCR off. After 30 minutes, turn the DVD/VCR on, and if theclock is not set automatically, set the clock manually (see page 25).•••Canadian Viewers:Please see note regarding the Auto Clock setting option on page 62.3 Press or to select your TimeZone, then press the ENTER.Time Zone setting (STANDARD TIME)4 Press SET UP MENU until the MENU screen is cleared.••Turn ON the TV.When a TV is connected with an audio/video cable, select the videoinput mode on the TV.When a TV is connected only with an antenna cable, set to thevideo channel 3 or 4. Then select VCR position with TV/VCR.Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Thenpress VCR to select the VCR mode. (The VCR indicator will light.)Preparation:••••In the rare event that you live within broadcast range of twostations in two different time zones, the DVD/VCR may recognizethe wrong station for the Auto Clock setting.To correct the situation:á+/ Ð /ENTER/MENU ñSYSTEM SETUPCLOCK SETLANGUAGE/IDIOMA/LANGUENO NOISE BACKGROUNDAUTO CLOCKSTANDARD TIMEON OFFON OFFDAYLIGHT SAVING TIMEá+/ Ð /ENTER/MENUñSTANDARD TIMEATLANTICCENTRALPACIFICEASTERNMOUNTAINALASKAHAWAIIAUTO••