3-7(6) Release the EVR mode of the VCR by transmitting thecode (F1) from the Jig RCU again. (When the EVR modeis released, the adjusted data is memorized.)(7) Repeat steps (2) to (6) in the mode (B2).Notes:• GND (Ground) should be taken from the D-PRE/RECboard shield case.• The signal level adjustment should be performed bysetting the center (centre) of the darkened section onthe CRT bright line.• After adjusting, always perform the confirmation andre-adjustment of the item 3.6.2.Signal (A1) • Ext. input(A2) • Optional(A3) • DF-300Mode (B1) • D-VHS STD(B2) • D-VHS HSAdjustment point (F1) (STD) • Jig code “96”(HS) • Jig code “91”(F2) • Jig code “9B”Specified value (G) • STOP modeAdjustment tool (H) • Jig RCU [PTU94023B](1) Insert the cassette tape (A3) to enter the mode (B1).(2) Set the VCR to the Auto adjust mode by transmitting thecode (F1) from the Jig RCU. When the VCR enters thestop mode, the adjustment is completed. When the VCRenters the eject mode, insert the cassette tape again.(3) Release the Auto adjust mode of the VCR by transmit-ting the code (F2)from the Jig RCU.(4) Repeat steps (2) to (3) in the mode (B2).3.6.2 PLL f0Notes:• This adjustment should be done after the “D-VHS REClevel adjustment” for the Digital circuit has been com-pleted.• Do not connect the probe or any other jig to the TP orshield case of the D-PRE/REC board during adjust-ment.• If auto adjustment is not completed by the above pro-cedure, re-adjust the adjustment item 3.6.1 again.Fig. 3-6-1a D-VHS REC levelawww.freeservicemanuals.info29/11/2016Published in Heiloo Holland
