JVC GR-DVL505 Instructions Manual

Contents

EN49SP 61S1SRRO2YEEUBNCVTNICIUDTHMDRROENMMODCOOOEODDPMEEYENOUNPLAYOFFPlay/Pause Button (4/6)DisplayPower SwitchSNAPSHOT Button Lock ButtonDubbing Images Recorded On A Tape ToThe Built-in MemoryImages can dubbed from a tape to the camcorder’s built-inmemory.1 Load a cassette ( pg. 12).2 Set the VIDEO/DSC Switch to “VIDEO”, then set thePower Switch to “ ” while pressing down theLock Button.3 Press the MENU/BRIGHT wheel. The Menu Screenappears. Rotate it to select “ ” and press it. “VIDEOMENU” appears.4 Rotate the MENU/BRIGHT wheel to select“ COPY” and press it. The Sub Menuappears. Rotate it to select “ON” and press it.Selection is complete.5 Rotate the MENU/BRIGHT wheel to select “1RE-TURN” and press it twice. The normal playbackscreen resumes.6 To select a video image to be dubbed, start playbackby pressing 4/6. At the moment you find the imageyou wish to dub, press it again to engage StillPlayback.7 Press MODE to select the Snapshot mode to use fordubbing the image to the built-in memory.8 To start dubbing, press SNAPSHOT. The selectedimage is stored in the built-in memory.•“ ” blinks during dubbing.NOTES:●If SNAPSHOT is pressed in step 8 when the built-inmemory is full, the message “COPYING FAILED”appears.●If an image recorded on the tape using the WIDE mode(pg. 26) is dubbed to the camcorder’s built-inmemory, the WIDE mode identifying signal is notdubbed with it.●To use Playback Special Effects with a video image youwish to dub, perform up to step 8 using the remotecontrol (provided) (pg. 53).MENU/BRIGHTWheelVIDEO/DSC Switch (Open theLCD monitor to access this switch.)MODE Button