JVC GM-V42S Instructions Manual

Also see for GM-V42PCE: Instructions Service manual

Contents

8PreparationsChecking the AccessoriesThe following accessories are included with the Monitor. Check for them. If any item is missing, please contact the dealer whereyou purchased the Monitor.• Remote control (RM-C579) x 1• Power cord x 2 (3 for Australia) (Use the one matching the wall outlet.)• Batteries (AA/R6P) x 2• BNC-RCA convension plug x 3 (For Australia)• Ferrite core x 1 (Except for GM-V42PCEB)Installing the BatteriesPut the batteries in the remote control as follows. If the remote control has become erratic in operation, change the batteries.1 Remove the back cover.While pushing the release lever on the cover, remove the cover inthe direction of the arrow.2 Place the batteries.Put the two supplied batteries (AA/R6P), noting the ª and ·markings, as shown.3 Replace the back cover as illustrated.Make sure the release lever on the cover is locked in place correctly.Precautions for using batteriesIf batteries are used improperly, the liquid could leak out, causing a fire, injury, etc. or dirtying the vicinity.Take notice of the following:• Do not mix old and new batteries.• Do not mix different types of battery as different types may have differentcharacteristics.• Place the batteries according to the ª and · markings indicated on the batterycompartment.• When installing the batteries, insert the · end first to avoid a short circuit.• Use only the specified batteries.• When you are not using the remote control for a long time, remove the batteries.• When the batteries have reached the end of their life, replace them with new onesimmediately. Otherwise, the liquid may leak out, or malfunction may be caused bythe leaked liquid. If the leaked liquid contacts your skin, wipe off the liquid with asoft cloth. If the affected skin is left as is, you may get a rough skin.• Do not throw the batteries into fire or try recharging them.• The service life of batteries is six months to one year for normal use. The suppliedbatteries are only for checking the operation and their life may be shorter. Whenthe remote control operation becomes erratic, replace with new batteries.Attaching the Ferrite Core (For GM-V42PCE, GM-V42PCEG, and GM-V42S)Attach the ferrite core to the power cord. Using the power cord without the ferrite core may lead to noise (interference). Openthe ferrite core, insert the power cord and close the ferrite core. Attach the ferrite core to the AC IN end of the power cord.The instruction below appliesonly to the use in Holland.Gebruike batterijen:Ferrite core *Power cord* Not supplied to GM-V42PCEBPlug to AC IN