JVC GET0641-001A Instruction & Installation Manual

Contents

3 – ENINSTRUCTIONSAudio amplifier sectionPower Output:20 W RMS × 4 Channels at 4 Ω and≤ 1% THD+NSignal-to-Noise Ratio:80 dBA (reference: 1 W into 4 Ω)Load Impedance: 4 Ω (4 Ω to 8 Ω allowance)Tone Control Range: Bass: ±12 dB at 60 HzMid-range: ±12 dB at 1 kHzTreble: ±12 dB at 7.5 kHzFrequency Response: 40 Hz to 20 000 HzLine-Out Level/Impedance: 2.5 V/20 kΩ load (full scale)Output Impedance: 1 kΩSubwoofer-Out Level/Impedance:2.5 V/20 kΩ load (full scale)If a kit is necessary for your car, consult your telephonedirectory for the nearest car audio speciality shop.Symptoms Remedies/CausesGeneral• Sound cannot be heard from the speakers. • Adjust the volume to the optimum level.• Check the cords and connections.• The buttons on the unit do not work as youintended.If you press M MODE, some buttons work differently from itoriginal function. Wait for 5 seconds or press M MODE again.• This unit does not work at all. Reset the unit.FM/AM • SSM automatic presetting does not work. Store stations manually.• Static noise while listening to the radio. Connect the antenna firmly.Disc playback• Disc ejects. Insert the disc correctly.• CD-R/CD-RW cannot be played back.• Tracks on the CD-R/CD-RW cannot beskipped.• Insert a finalized CD-R/CD-RW.• Finalize the CD-R/CD-RW with the component which you usedfor recording.• Disc can be neither played back nor ejected. • Unlock the disc.• Eject the disc forcibly.• Disc sound is sometimes interrupted. • Stop playback while driving on rough roads.• Change the disc.• Check the cords and connections.• “NO DISC” appears on the display.• “PLEASE” and “EJECT” appear alternatelyon the display.Insert a playable disc into the loading slot.MP3/WMA playback• Disc cannot be played back. • Use a disc with MP3/WMA tracks recorded in a format compliantwith ISO 9660 Level 1, Level 2, Romeo, or Joliet.• Add the extension code <.mp3> or <.wma> to the file names.• Noise is generated. Skip to another track or change the disc. (Do not add the extensioncode <.mp3> or <.wma> to non-MP3 or WMA tracks.)• A longer readout time is required(“READING” keeps flashing on the display).Do not use too many hierarchical levels and folders.• Tracks are not played back in the order youhave intended.Playback order is determined when the files are recorded.• The elapsed playing time is not correct. This sometimes occurs during playback. This is caused by how thetracks are recorded on the disc.• The correct characters are not displayed(e.g. album name).This unit can only display alphabets (upper case), numbers, and alimited number of symbols.• Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the UnitedStates and/or other countries.Indication Item ( : Initial) SettingDEMO • DEMO ON• DEMO OFF: Display demonstration will be activated automatically if no operation is donefor about 20 seconds.: Cancels.CLK DISP * 1 • ON• OFF: Clock time is shown on the display at all times when the power is turned off.: Cancels; pressing DISP will show the clock time for about 5 seconds when thepower is turned off.CLOCK H (Hour) 1 – 12 : [Initial: 1 (1:00)]CLOCK M (Minute) 00 – 59 : [Initial: 00 (1:00)]DIMMER • ON• OFF: Dims the display and button illumination.: Cancels.SCROLL * 2 • ONCE• AUTO• OFF: Scrolls the displayed information once.: Repeats scrolling (at 5-second intervals).: Cancels.• Pressing DISP for more than one second can scroll the display regardless ofthe setting.L/O MODE • REAR• WOOFER: Select if the REAR LINE OUT terminals are used for connecting the speakers(through an external amplifier).: Select if the REAR LINE OUT terminals are used for connecting a subwoofer.WOOFER * 3 • LOW• MID• HIGH: Frequencies lower than 90 Hz are sent to the subwoofer.: Frequencies lower than 135 Hz are sent to the subwoofer.: Frequencies lower than 180 Hz are sent to the subwoofer.AUX ADJ A.ADJ 00– A.ADJ 05: Adjust the auxiliary input level to avoid the sudden increase of the outputlevel when changing the source from external component connected to theAUX input jack on the control panel.TAG DISP • TAG ON• TAG OFF: Shows the Tag while playing MP3/WMA tracks.: Cancels.AMP GAIN * 4 • LOW PWR• HIGH PWR: VOL 00 – VOL 30 (Select if the maximum power of each speaker is less than50 W to prevent damaging the speaker.): VOL 00 – VOL 50AREA • AREA US• AREA EU• AREA SA: When using in North/Central/South America. AM/FM intervals are set to10 kHz/200 kHz.: When using in any other areas. AM/FM intervals are set to 9 kHz/50 kHz(100 kHz during auto search).: When using in South American countries where FM interval is 100 kHz.AM interval is set to 10 kHz.*1 If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select “OFF” tosave the car’s battery.* 2 Some characters or symbols will not be shown correctly (or will be blanked) on the display.* 3 Displayed only when “L/O MODE” is set to “WOOFER.”* 4 The volume level automatically changes to “VOL 30” if you change to “LOW PWR” while the volume level is set higher than“VOL 30.”TROUBLESHOOTINGGeneralPower Requirement: Operating Voltage: DC 14.4 V(11 V to 16 V allowance)Grounding System: Negative groundAllowable Operating Temperature:0°C to +40°C (32°F to 104°F)Dimensions (W × H × D):Installation Size (approx.):182 mm × 52 mm × 160 mm(7-3/16” × 2-1/16” × 6-5/16”)Panel Size (approx.):188 mm × 58 mm × 5 mm(7-7/16” × 2-5/16” × 1/4”)Mass (approx.):1.3 kg (2.9 lbs) (excluding accessories)Design and specifications are subject to change withoutnotice.SPECIFICATIONSTuner sectionFrequency Range:FM: 87.5 MHz to 107.9 MHz(with channel interval set to 100 kHz or 200 kHz)87.5 MHz to 108.0 MHz(with channel interval set to 50 kHz)AM: 530 kHz to 1 710 kHz(with channel interval set to 10 kHz)531 kHz to 1 602 kHz(with channel interval set to 9 kHz)[FM Tuner]Usable Sensitivity: 11.3 dBf (1.0 μV/75 Ω)50 dB Quieting Sensitivity: 16.3 dBf (1.8 μV/75 Ω)Alternate Channel Selectivity (400 kHz): 65 dBFrequency Response: 40 Hz to 15 000 HzStereo Separation: 35 dB[AM Tuner]Sensitivity/Selectivity: 20 μV/35 dBCD player sectionType: Compact disc playerSignal Detection System: Non-contact optical pickup(semiconductor laser)Number of channels: 2 channels (stereo)Frequency Response: 5 Hz to 20 000 HzDynamic Range: 93 dBSignal-to-Noise Ratio: 98 dBWow and Flutter: Less than measurable limitMP3 Decoding Format: MPEG1/2 Audio Layer 3Max. Bit Rate: 320 kbpsWMA (Windows Media® Audio) Decoding Format :Max. Bit Rate: 192 kbpsHaving TROUBLE with operation?Please reset your unitStill having trouble??Call 1-800-252-5722 (USA ONLY)http://www.jvc.comGeneral settings—PSMSelect an item. Adjust. FinishEnter PSM menu.To keep discs cleanWipe in a straight line from center of disc toedge. Do not use liquid cleaners, thinners, orbenzene.To play new discsRemove any rough areas from the inner andouter edges of the disc.MAINTENANCEHow to clean the connectorsWipe the connectors witha cotton swab or clothmoistened with alcohol.Moisture condensationMoisture may condense on the lens inside the unit. Ejectthe disc and leave the unit turned on for a few hours untilthe moisture has evaporated.Do not use the following discs:Warped disc Sticker and sticker residue Stick-on labelUnusual shapeSingle CD—8 cm (3-3/16”) discConnectorsC-thru Disc (semi-transparent disc)Transparent or semi-transparentparts on its recording area

/ 4

Related manuals for JVC 0709DTSMDTJEIN