JVC DR-MX1S Instructions Manual

Also see for DR-MX1S: Instructions Quick start guide Instructions Gebruiksaanwijzing

Contents

EN 75EDITINGYou can use a camcorder as the source player and your unit as therecording deck.1 Make connections.A If the camcorder has no S-VIDEO output connector:— connect the camcorder’s AUDIO/VIDEO OUT connectors to theunit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors on the frontpanel.● When using a monaural camcorder, connect its AUDIO OUTconnector to the [AUDIO-L] input connector on your unit.B If the camcorder has an S-VIDEO output connector:— connect the camcorder’s AUDIO OUT and S-VIDEO OUTconnectors to the unit’s [AUDIO] and [S-VIDEO] input connectorson the front panel.2 Press VHS/HDD/DVD SELECT on the unit repeatedly to selectthe recording deck.3 Press CH +/– to select “F-1”.● Set “FRONT AUX F-1” to “VIDEO” for the VIDEO input connector, or“S-VIDEO” for the S-VIDEO input connector, depending on theconnector being used. ( pg. 83)4 Press REC MODE repeatedly to set the recording mode.5 Start playback on the camcorder slightly before the actual pointfrom where you wish to start dubbing.6 Press 7 on the unit to start recording. Or while holding 7, press4 on the remote control. The dubbing starts.7 Press 8 on the unit, then stop playback on the camcorder.NOTES:● All necessary cables can be obtained from your dealer.● Refer to the camcorder’s instruction manual for operating procedure.● The quality of dubbed picture becomes poorer than that of theoriginal.Edit From A CamcorderA If the camcorder has no S-VIDEO output connector:RecorderPlayerTo [VIDEO/AUDIO((MONO) L/R)] inputAudio/video cable(not supplied)AUDIO/VIDEO OUTB If the camcorder has an S-VIDEO output connector (HDD& DVD deck only):To[S-VIDEO]inputTo [AUDIO] inputS-video cable(not supplied)AUDIO OUTAudio cable(not supplied)S-VIDEO OUTRecorderPlayer● Slide the TV/CABLE/DBS/DVD switch to DVD.