JVC DR-MV1 Instructions Manual

Also see for DR-MV1: Instructions Instructions

Contents

EN 73EDITINGNOTES:● If you have a satellite receiver or a decoder connected to the L-2 IN/DECODER connector, be sure to set “L-2 SELECT” back toappropriate mode after editing.● If you are not connecting a satellite receiver or a decoder to the L-2IN/DECODER connector, leave “L-2 SELECT” set to “VIDEO”.● When “L-2 SELECT” is set to “SAT VIDEO” and “SAT S-VIDEO”,“SAT” appears on the TV screen or front display panel instead of“L-2”.● If “L-1 OUTPUT” is set to “SCART S-VIDEO”, it is not possible to set“L-2 SELECT” to “DECODER” or “SAT VIDEO”.● If “L-1 OUTPUT” is set to “SCART RGB”, it is not possible to set “L-2SELECT” to “DECODER” or “SAT S-VIDEO”.● If “L-1 OUTPUT” is set to “COMPONENT” and “L-2 SELECT” to “SATVIDEO”, “SAT S-VIDEO” or “DECODER”, be sure to connect the L-1IN/OUT connector with a TV.F-1 Input SettingSet “F-1 INPUT” to the appropriate mode depending on theconnector (VIDEO or S-VIDEO) being used on the front panel.1 Perform steps 1 and 2 of “L-1 Output And L-1 Input Setting”( pg. 72).2 Press rt to select “F-1 INPUT”, then press ENTER.3 Press rt to select theappropriate setting, then pressENTER.4 Press SET UP to complete thesetting.* The boldface settings belowindicate the settings at yourpurchase.8 F-1 INPUT — VIDEO / S-VIDEOVIDEO: When connecting an appliance to the VIDEO inputconnector, set to “VIDEO”.S-VIDEO: When connecting an appliance to the S-VIDEO inputconnector, set to “S-VIDEO”.You can dub selected audio from a DVD or Audio CD disc to adigital audio device.However, it is not possible to dub copy-protected discs.Example: Dubbing to an MD1 Connect the unit and a digital audio device using either anoptional optical cable or an optional coaxial cable.2 Place a disc on the unit and load an MD on the connected digitalaudio device.3 Select the audio to be dubbed.4 Start playback slightly before the actual point from where youwish to start dubbing.5 Press 9 to pause playback.6 Select the input mode on the connected digital audio device.7 Press 4 to start playback on the unit.8 Start recording on the digital audio device.9 Stop recording on the digital audio device. Then press 8 to stopplayback on the unit.NOTE:There may be a discrepancy of several seconds between where youintend editing to start, and where it actually starts.Digital Audio Dubbing● Turn on the TV and select the AV mode.● Slide the TV/CABLE/SAT/DVD switch to DVD.2Rear of unitNote for connection:Remove the protectioncap from the cable.Digital audio device(MD deck, etc.)Optical cable(not supplied)DIGITAL AUDIO OUT(OPTICAL)PlayerRecorderCoaxial cable(not supplied)DIGITAL AUDIO OUT(COAXIAL)