CU-VD40Easy and correct way of copying to a DVD(See overleaf on playing back the DVD)1. Get ready a recommended discPlease use the recommended discs stated below.Using discs other than those recommended may cause problem when copying to the DVDand when playing back the DVD.Recommended discsDVD-R DVD-RW DVD-R DL(single-sided double layer)Brand JVCTDKVerbatimSONYJVC JVCVerbatimCautionOnly DVD-R and DVD-RW discs can be used.DVD-R DL (single-sided double layer) discs can only be used for High definition Everio.Recording and playback may not function properly if the recording side is scratched or dirty.•••2. Set up each device before copyingHigh definitionEverioCU-VD40321 4Dedicated USB cable1 Connect the USB cable2 Turn on CU-VD40After turning on the power, wait for approximately 20 seconds beforeproceeding to step 3 .The burner may not function properly within this 20 seconds.3 Turn on the EverioThe power lamp of CU-VD40 turns from orange light to green light.•4 Insert a new recommended disc into CU-VD40Next, operate the Everio. Proceed to step 3.3. Copy all images to the DVDPerform operations on the Everio.(Everio LCD screen display)1 Confirm that the display on the rightappears on the Everio LCD screen.2 Select “NORMAL BACK-UP”1 Select(move up and down)2 Confirm(press down)3 Select “ALL”1 Select(move up and down)2 Confirm(press down)4 Select “EXECUTE AND FINALIZE”1 Select(move up and down)2 Confirm(press down)Playback is not possible if the disc is notfinalized.Wait for the “copy in progress” screen on theright and the “hourglass” mark to disappear,then turn off the power and disconnect theUSB cable.••5 ExitConfirm(press down)Copying completed!“Copy in progress” screenLYT1752-013A0707MNH-SW-BJIMPORTANTPlease read carefully before use.NoteThere are other ways of copying which includes copying only the desired files.For details, refer to the instruction manual of Everio.•