Menu
JVC CA-MXS6MDR Service Manual
Also see for CA-MXS6MDR: Instructions
                                                                     |
1-7CA-MXS6MDRSP-MXS6MDPrior to performing the following procedure, removethe top cover.Disconnect the wire from connector CN603 on theinput board and the card wire from CN801 on themicrocomputer board.Remove the two screws E on the bottom of the body.Release the joint a on the bottom and the two jointsb and c on the lower sides of the body using ascrewdriver. Detach the front panel assembly towardthe front.1.2.3.Removing the font panel assembly(See Fig.6 to 8)Prior to performing the following procedure, removethe top cover and the front panel assembly.Remove the nine screws F attaching the displayboard to the front panel assembly.Disconnect connector CN791 on the display boardfrom the control board on the front panel assembly.1.2.Removing the display board (See Fig.9)Prior to performing the following procedure, removethe top cover, the front panel assembly and thedisplay board.Remove the five screws G and the four screws Hattaching the control board and the key board.1.Removing the control board / the keyboard (See Fig.10)When removing the control board andthe key board respectively, unsoldereach board.REFERANCE:Fig.8Front panel assembly Joint aJoint bJoint cFront panel assemblyCN603CN801Microcomputer boardDisplay boardKey boardControl boardInput boardE EFGGGHHFFFFig.6Fig.7Fig.9Fig.10Front panel assemblyFront panel assemblySolderingFront panel assemblyCN791 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved