JVC AV-P950E Instructions Manual

Also see for AV-P950E: Instructions

Contents

8Rear panelREMOTE INPUT (RS-232C)EXT INPUT RGB OUTPUT 1 RGB OUTPUT 2MODEA B C D E F10DC OUTPUTDC12V 400mAMODEUse to set the RGB output picture mode or sync signalmode. Set it according to the specifications of theconnected projector or display.Use to control the unit from a personalcomputer via RS-232C(see page 16).REMOTE INInput RGB signals such as video signal from a personalcomputer, or sync signal.Use to input RGB signals such as video signals from apersonal computer, and sync signals. Select the pictureto be shown instead of the camera picture using the EXTIN button of SOURCE SELECT on the control panel.• Input signals will be transferred directly to RGBOUTPUT 1 and RGB OUTPUT 2, regardless of thepicture mode settings of RGB OUTPUT on this unit.• Set the signal of the equipment connected to theEXT INPUT connector according to thespecifications of the connected projector or display.EXT INPUTRGB OUTPUT1, RGB OUTPUT2Outputs camera pictures or signals from EXTINPUT.RGB OUTPUT1, RGB OUTPUT2A B C D E F10• All switches arefactory-set to “1”.• When using either SVGA or VGA mode,the picture quality will be slightly inferiorto that of XGA mode.Mode setting for the RGBoutput pictureA BXGA (1024 X 768) ........ 1 1SVGA (800 X 600) ........ 0 1VGA (640 X 480) ........ 0 0Preview mode setting 1 .... OFF(see page 14) 0 .... ONMenu display setting 1 .... Display0 .... No display• If No Display is selected for the MENU Display settingwhile the PREVIEW mode setting is ON, this setting will beapplicable only with the RGB output pictures.Setting of sync signal for 1 .... NO (not added)G signal from RGB OUTPUT 0 .... YES (added)Mode setting for sync 1 .... Horizontal sync signalsignal from RGB OUTPUT 0 .... Composite sync signal