JVC AV-P1000U Operating Instructions Manual

11ENGLISHAUTO WHITE SET● This adjusts the picture tone.● Shoot a white sheet of paper in full screen and press theAUTO WHITE SET button. The indicator blinks until the whitebalance is set. When the white balance setting is complete,the indicator stops blinking and remains lit.● Press the FOCUS buttons to adjust the focus.● Press the NEAR button to focus on the upper (closer) partof the object and the FAR button to focus on the lower(farther) part.FOCUS● This freezes the picture from the camera and displays it as astill image. The indicator lights.● Press again to release the still mode. The indicator goes out.● When the split mode is engaged using the ON-SCREEN AD-JUSTMENTS, the screen is divided. The still picture is shownon one side and the current camera picture on the other. Theindicator blinks.FREEZEON-SCREEN ADJUSTMENTS ZOOMFOCUSFARNEARWIDETELELIGHTS IRIS MENU/ENTERVIDEOOUTPC FREEZE AUTO WHITESET DIGITALPRESET1 2Note : Focusing range is up to 100 mm from the stage sur-face.* Even though the auto white set mode is engaged, the toneis not adjusted unless this button is pressed.* When the lighting changes, perform the auto white set op-eration again.* The auto white set mode and the manual mode can be switchedwith the ON-SCREEN ADJUSTMENTS (p. 14 and 15).Note : In the manual white balance mode, this button has noeffect. In this case, “MANUAL WB” is shown briefly inthe upper left of the screen for confirmation.ON-SCREEN ADJUSTMENTS ZOOMFOCUSFARNEARWIDETELELIGHTS IRIS MENU/ENTERVIDEOOUTPC FREEZE AUTO WHITESET DIGITALPRESET1 2* For the split mode setting, refer to p. 14 and 15.Note : When the still mode is engaged, zoom, focus and irisadjustments are not possible. Also, the VIDEO OUTbutton has no effect.ON-SCREEN ADJUSTMENTS ZOOMFOCUSFARNEARWIDETELELIGHTS IRIS MENU/ENTERVIDEOOUTPC FREEZE AUTO WHITESET DIGITALPRESET1 2