JVC AV-20FD24 Service Manual

Also see for AV-20FD24: User guide User guide

Contents

12AV-20FD24No. 52133NOTE1. In case of the Idler Arm installation, install as the circled sectionof Fig. 2-10-B.2. In case of the Idler Arm Spring installation, install as the circledsection of Fig. 2-10-C.3. In case of the Chassis Spring installation, install as the circledsection of Fig. 2-10-D.Fig. 2-10-BFig. 2-10-CFig. 2-10-DIdler ArmMain Chassis Ass’yIdler Arm SpringMain Chassis Ass’yChassis SpringMain Chassis Ass’y2-11: FEED MOTOR (Refer to Fig. 2-11-A)1. Remove the 2 screws 1.2. Remove the Feed Motor.3. Remove the Motor Gear.Fig. 2-11-A• Screw Torque: 1 ± 0.5kgf•cm1 1Main Chassis Ass’yMotor GearFeed MotorNOTE1. In case of the Motor Gear installation, check if the valueof theFig. 2-11-B is correct.2. When installing the Feed Motor, check if the cable is positionedas Fig. 2-11-C.Fig. 2-11-BMotor GearFeed Motor6.1 ± 0.1mmSafety surface for pressingof the insert.Fig. 2-11-CMain Chassis Ass’yFeed MotorPass the cablebetween 2 pins.