JVC 0905TNH-FN-FN Instructions Manual

Contents

20Getting StartedENManual TuningManually tune each channel.1 In stop mode, press [SET UP].“Easy Setting Menu” or “Advanced Setting Menu”will appear.2 Select “Channel” using[Cursor U / D], then press [ENTER].3 Select “Manual Tuning” using[Cursor U / D], then press [ENTER].4 Select “Position” using[Cursor U / D], then press [ENTER].5 Select the position number you wishto use using [the Number buttons] or[Cursor U / D], then press[RETURN].You can select position numbers 01 to 99.6 Select “Channel” using[Cursor U / D], then press [ENTER].7 Press [Cursor U / D] to startscanning.• The tuner will begin to search up or downautomatically. When a channel is found, the unitwill stop searching and the picture will appearon the TV screen.• You can select a desired channel number using[the Number buttons]. Refer to the followingChannel Plan table and press the three digits toselect the channel number.(To select channel 4, press [0] first and thenpress [0] and [4]. Or press [4] and then “– – 4”appears and wait for 2 seconds.)• If this is the channel you want, press [RETURN].This unit can receive the Hyper and Oscarfrequency bands.• If “Skip” is set to “ON,” select “Skip” using[Cursor U / D], then press [ENTER]. Select“OFF” using [Cursor U / D], then press[RETURN].• If you want to decode scrambled signals, select“Decoder” using [Cursor U / D], then press[ENTER]. Select “ON” using [Cursor U / D],then press [RETURN].• To store another channel, repeat steps 4 to 7.8 After completion, press [SET UP] toexit.To Select a ChannelNotes on using the Number buttons:• Enter channel numbers as a two-digit number forthe quickest result. For example, to select channel6, press [0] and [6]. If you only press [6], channel 6will be selected after 2 seconds. You can only selectchannels 1 to 99.• You can select the external input mode “AV1,” “AV2”or “AV3.”• To select “AV1,” press [0], [0], [1].• To select “AV2,” press [0], [0], [2].• To select “AV3,” press [0], [0], [3].To Skip a Preset ChannelYou can set the unit to skip channels you can nolonger receive or seldom watch when you accesschannels using [PR +/-].1 Follow steps 1 to 3 in “ManualTuning.”2 Select “Position” using[Cursor U / D], then press [ENTER].3 Select the position number you wishto skip using [the Number buttons]or [Cursor U / D], then press[RETURN].4 Select “Skip” using [Cursor U / D],then press [ENTER].5 Select “ON” using [Cursor U / D],then press [RETURN].• To skip another channel, repeat steps 2 to 5.6 Press [SET UP] to exit.Channel PlanCh. Indication TV Channel02 - 12 E2 - E1213 - 20 A - H (only ITALY)21 - 69 E21 - E6974 - 78 X, Y, Z, Z+1, Z+280 - 99, 100 S1 - S20, GAP121 - 141 S21 - S41Channel 12Decoder OFFSkip ONPosition P01Manual Tuning VCR DVD