JVC 0808TKH-FU-FU User Manual

27ENINTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTINGWATCHING TV OPERATING DVD SETTING DVD TROUBLESHOOTING INFORMATION5 Press [SETUP] to exit.Note:• Adjust the “Phase” setting after the “Clock” setting hasbeen properly adjusted.• You may not obtain an appropriate screen with autoadjustment for some signals. In this case, adjust thesettings manually.HDMI AudioYou can set the method of sound input for the HDMI 1-IN jack.1 Repeat steps 1 and 2 in “Closed Caption”on page 22.2 Use [Cursor K / L] to select “HDMI1 Audio”, then press[ENTER].Power onAutoClosed CaptionV–chipPC SettingsHDMI1 AudioBlue LEDDetailDetail3 Use [Cursor K / L] to select the desired sound input,then press [ENTER].DetailDetailClosed CaptionAutoDigitalAnalogV–chipPC SettingsHDMI1 AudioBlue LEDHDMI1AudioAutoSelect if you have connected bothdigital device to the HDMI 1-INjack and analog device to theaudio sources. Digital audio inputsignal will have priority.DigitalSelect if you have connecteddigital device to the HDMI 1-INjack for digital audio input signal.AnalogSelect if you have connectedanalog device to the analog audiojacks for analog audio input signal.4 Press [SETUP] to exit.5Blue LEDYou can set the blue LED on the front panel to light up when the unit isturned on or when a disc is inserted.1 Repeat steps 1 and 2 in “Closed Caption”on page 22.2 Use [Cursor K / L] to select “Blue LED”, then press[ENTER].Power onAutoClosed CaptionV–chipPC SettingsHDMI1 AudioBlue LEDDetailDetail3 Use [Cursor K / L] to select the desired setting, thenpress [ENTER].Disc inPower onOffBlue LEDBlue LEDThis function sets the Blue LED.When TV is on,Power on:LED is always on.Disc in:When disc is inserted, LED is on.When disc is not inserted, LED is off.Off:LED is always off.Blue LEDPower on Lights up while the unit is turnedon.Disc in Lights up when a disc is inserted.Lights off when there is no disc.Off Turns off the Blue LED.4 Press [SETUP] to exit.5